Votes - 2, Average rating: 3.5 ( )

Manafacture: Air King File size: 171.98 kb File name: Language of manual:

Customer Service Dept., 820 Lincoln Ave., West Chester, PA 19380 (Please do not send product to this location) PARTS FOR DISCONTINUED, OBSOLETE AND CERTAIN OTHER PRODUCTS MAY NOT BE AVAILABLE. DUE TO SAFETY REASONS, MANY ELECTRONIC COMPONENTS AND MOST HEATER COMPONENTS ARE NOT AVAILABLE TO CONSUMERS FOR INSTALLATION OR REPLACEMENT. SAVE THESE INSTRUCTIONS Rev. C 9/07 5084413 4 1 5084413 Rev. C 9/07 IMPORTANT INSTRUCTIONS - OPERATING MANUAL IMPORTANT INSTRUCTIONS - OPERATING MANUAL CAUTION: TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR PERSONAL INJURY, ONLY USE WITH ONE OF THE FOLLOWING AIR KING MODELS; 9100PB, 9100WC, 9100CM, 9100WB, 9100I. PRODUCT USAGE To complete this Air King® High Velocity Head Assembly use any of the following Air King® products: Model # 9100PB - Pedestal and Base Kit Model # 9100WC - Wall Mount Kit Model # 9100CM - Ceiling Mount Kit Model # 9100WB - Wheel Kit Model # 9100I - I-Beam Kit See Related Product For Assembly Attachment Instructions. OPERATING INSTRUCTIONS 1.TO OPERATE: Plug cord into a grounded 120V, 60 Hz outlet. Select desired operating speed with pull cord on the rear of the motor: First pull: High Second pull: Medium Third pull: Low Fourth pull: OFF NOTE: THIS FAN IS VERY HEAVY. Failure to securely hold onto head assembly while adjusting head angle could result in personal injury. 2.TO ADJUST HEAD ANGLE: While holding head firmly, loosen knob under motor (turn counterclockwise). Tilt head to desired position FIRMLY retighten knob under motor. NOTE: Motor Head Adjustment Knob and the On/Off Pull Cord have the same location on oscillating or non-oscillating models. NOTE: The Grill and Blade should be installed AFTER the Motor Head Assembly has been properly mounted. GRILL AND BLADE ASSEMBLY (Figures 1 and 2) NOTE: The assembly of the blade and grill are identical, regardless if the Fan has an oscillating motor or a non-oscillating motor. One of each is shown in the illustrations below. 1.Install the Rear Grill onto the Motor, lining up the six holes in the grill with the six threaded holes in the Motor. Install (6) 10-32 X 5/16" Hex Screws through the Rear Grill into the Motor. Securely tighten all (6) screws. (Figure 1) 2.Push the Fan Blade onto the Motor Shaft, centering the Hub facing away from the motor, until it stops against the shaft. (Inset A) Align Square Head Bolt with flat of the Motor Shaft. TIGHTEN VERY SECURELY WITH AN ADJUSTABLE WRENCH. Failure to securely tighten the Bolt could result in damage to the Fan and/or personal injury. 3.Hold the Front Grill so that the name, in the center, is right side up and straight across. Starting at the top: Fasten Front Grill to Rear Grill by sliding the hooked wires on the Front Grill over the outermost ring on the Rear Grill. (Figure 2 / Detail A) The bottom most hooks will require the use of a flathead screwdriver to complete assembly. Stand behind the Fan. Slip the flat of the screwdriver between the Front and Rear Grills, next to on...

Download now

Please, enter two numbers from picture: