Votes - 3, Average rating: 4.3 ( )

Manafacture: Air King File size: 68.18 kb File name: Language of manual:

3. Loosen knob and return head to a vertical postion. Retighten knob. 4. Push fan blade onto motor shaft, center hub facing away from motor, until it stops against shaft. Align bolt head set screw with flat of the motor shaft. TIGHTEN VERY SECURELY WITH AN ADJUSTABLE WRENCH. Failure to securely tighten set screw could result in damage to the fan and/or personal injury. 5. Hold the front grill so that the name, in the center, is right side up and straight across. Starting at the top: Fasten front grill to rear grill by sliding the hooked wires on the front grill over the Outermost Ring on the rear grill. (Figure 4-Detail A) New 3/04 OPERATING INSTRUCTIONS 1.)TO OPERATE: Plug cord into a grounded 120V, 60 Hz outlet. Select desired operating speed with pull cord on the rear of the motor: First pull: High Second pull: Medium Third pull: Low Fourth pull: OFF NOTE: This fan is very heavy. Failure to securely hold onto head assembly while adjusting head height or head angle could result in personal injury. 2.)TO ADJUST HEAD ANGLE: While holding head firmly, loosen knob under motor (turn counterclockwise). Tilt head to desired position FIRMLY retighten knob under motor. 3.)TO ADJUST HEAD HEIGHT: While holding upper column firmly, loosen set screw on column collar (turn counterclockwise). Raise or lower head to desired position. FIRMLY retighten set screw. NOTE: Motor Head Adjustment Knob, On/Off Pull Cord and Set Screw Placement have the same location on oscillating or nonoscialling models. - NEVER use maintenance, should be performed by an authorized service representative. Call 1-800-233-0268, Monday through Friday, between the hours of 8:00 a.m.and 5:00 p.m. for the location of your nearest service center. LUBRICATION: Precision bearings are sealed at the factory for life and do not require further lubrication. STORAGE: Store the Fan, with these instructions, in a clean and dry place. 3 5084415 justment Knob over the remaining threads. COLUMN TO BASE ASSEMBLY 1. Rest Column and Head Assembly on floor next to the Base As- sembly. Tilt Base Assembly up on end. Pick up Lower Pipe of Column and insert bottom of Pipe into the Mounting Flange. 2. Tilt entire Assembly (base and head) upright. Confirm that the column is fully seated in Mounting Flange. Insert and securely tighten the 3/8"-16 x 3/4" Allen Set Screw in Mounting Flange with the Allen Wrench (supplied in parts bag). Make sure Screw is fully tightened and there is NO looseness between Column and Mounting Flange. 6. The bottom most Hooks will require the use of a flathead screw- driver to complete assembly. Stand behind Fan. Slip the flat of the blade between the front and rear grills, next to one of the unfastened hooks. (Figure 4-Detail B) Pull screwdriver handle upwards towards the rear grill. Slip the front grill hook over the rear grill outer ring with a push. Repeat procedure with remaining Hooks. Caution: Be careful not to bend any wires on grills or pinch your hands during assembly. 7. Atta...

Download now

Please, enter two numbers from picture: