Votes - 3, Average rating: 4.7 ( )

Manafacture: Electrolux File size: 718.29 kb File name: Language of manual:

Locate flame generation cylindrical drum (see Figure 7). It is constructed of two removable halves; either of which can be removed from the unit. 3. Squeeze half of drum cylinder until it's top edge clears the top drum track (see Figure 8). Remove bottom edge of cylinder drum from bottom drum track. This will give you access to the light bulbs. Note: Do not exert excessive pressure on drum cylinder as this may cause damage. 4. Remove spring clip. Hold socket and pull out old bulb. 5. Hold socket and push in new bulb (DO NOT exceed wattage). Replace spring clip. 6. Repeat steps 3 and 4 for second bulb. 7. Insert bottom edge of removed cylinder half into bottom drum track. Gently squeeze drum cylinder until it's top edge fits into top drum rack. 8. Replace louvered back panel. Replacing Glass 1. Remove top of stove by sliding top toward the back (see Figure 9). Top fits into slots and should slide off easily. 2. Remove four screws securing back control panel (see Figure 10). DO NOT STRESS WIRES. 3. Remove four screws securing heater/blower assembly to stove assembly (see Figure 10). Assembly must be held securely while removing screws. Cleaning and Maintenance Continued Top of Stove Figure 9 - Removing Top of Stove Glass Panel Heater/Blower Assembly Flame Cylinder Drum Figure 7 - Flame Cylinder Drum Location Flame Cylinder Drum Back Control Panel Figure 8 - Flame Generation Cylinder Drum Figure 10 - Removing Glass Panel 4. Slide heater assembly out back of stove and set aside (see Figure 10, page 7). 5. Slide glass up through top of stove. 6. Slide new glass into place between glass retainers. 7. Replace heater/blower assembly using screws removed in step 3, page 7. 8. Replace back control panel using screws removed in step 2, page 7. 9. Slide top of stove back into slots. Replacing Log 1. Follow steps 1 through 4 under Replacing Glass, page 7, to allow access to log. 2. Carefully pull up on log to remove from stove cavity. 3. Place replacement log into stove. 4. Follow steps 5 through 8 under Replacing Glass to complete this procedure. Cleaning Front panel glass WARNING: When cleaning unit, the power supply should be disconnected and the unit should be cool. Over time the front glass panel may become dirty or dusty. Dust can be removed by lightly rubbing the glass surface with a clean, lint free cloth or paper towel. To remove fingerprints or other marks, use a damp cloth with a good quality household glass cleaner. The front glass panel should be completely dried with a clean, lint free cloth or paper towel. CAUTION: Do not use abrasive cleaners on glass panel. Do not spray liquids directly onto any surface of the unit. WARNING: An authorized service representative should perform any other servicing. Storage When not in use, unplug the unit from the power supply and store in dry, dust free location. Technical Service You may have further questions about your electric stove. If so, contact DESA Heating Products’ Technical Service Department at 1-8...

Download now

Please, enter two numbers from picture: