Votes - 4, Average rating: 3.8 ( )

Manafacture: Electrolux File size: 2.08 mb File name: Language of manual:

Do not leave water bath or pressure canners on high heat for an the required time. When canning with extended amount of time. a pressure canner, the pressure must 3. Alternate surface units between each batch to allow the units and be maintained continuously for the surrounding surfaces to cool down. Try to avoid canning on the same required time. !iI................... burner unit all day. ........... ii....... Flame Size For most cooking, start on the highest control setting and then turn to a lower one to complete the process. Use the table below as a guide for determining proper flame size for various types of cooking. The size and type of utensil used and the amount of food being cooked will influence the setting needed for cooking. For deep fat frying, use a thermometer and adjust the surface control knob accordingly. If the fat is too cool, the food will absorb the fat and be greasy. If the fat is too hot, the food will brown so quickly that the center will be undercooked. Do not attempt to deep fat fry too much food at once as the food will neither brown nor cook properly. *Flame Size Type of Cooking High Flame Start most foods; bring water to a boil; pan broiling Medium Flame Maintain a slow boil; thicken sauces, gravies; steam Low Flame Keep foods cooking; poach; stew *These settings are based on using medium-weight aluminum pans with lids. Settings may vary when using other types of pans. Never extend the flame beyond the outer edge of the utensil. A higher flame simply wastes heat and energy, and increases your risk of being burned by the flame. Proper Burner Adjustments The color of the flame is the key to proper burner adjustment. A good flame is clear, blue and hardly visible in a well-lighted room. Each cone of flame should be steady and sharply defined. Adjust or clean burner if flame is yellow-orange. To clean burner, see instructions under General Cleaning. Surface Cooking Placement of Burner Bases and Caps (Models with sealed burner only) Your cooktop is equipped with three different sized burners: Power Burner (large), Standard Burner (medium) and Simmer Burner (small). Place the burner base over each gas opening, matching the burner base size with the gas opening size. Place the burner cap on each burner base, again matching the cap size to the burner base size. The cap for the each Burner has an inner locating ring which locates the burner cap in the center of the burner. Make sure each burner cap is properly aligned and level. Turn the burner on to determine if it will light. If the burner does not light, contact a Sears Service Center. Do not service the sealed burner yourself. Sealed Burner Setting Surface Controls The surface control knobs shown Open Burner Models below may not look identical to the To Adjust Low or "Simmer" Setting (some models) Surface Controls Knobs on your The burner flame, at low setting, can be adjusted if it is too high or too low; range; They are only representa...

Download now

Please, enter two numbers from picture: