Votes - 3, Average rating: 4.3
(
)
)
|
manual abstract
BOTTLES 7) Fill the bottles with cool, fresh, preferably unsoftened water. If you have only softened water available in your home, you may use it, but you will notice a buildup of minerals on the wick much sooner. The bottles hold 2.75 gallons each. When filling the bottles, be careful not to pressurize them by over filling. Bottle damage can result from this. To reduce carrying weight, the bottle may be partially filled and unit will still operate properly. A fill hose is provided with your humidifier which will fit most faucets. 8) We recommend using Bemis by Essick Air Bacteria treatment whenever you refill the water bottles to eliminate bacterial growth. Add bacteriostat according to the instructions on the bottle and then tighten the valve caps on your water bottles. 9) Place water bottles into the humidifier with the valve cap end down and to the back of the humidifier so that the valve cap enters the water channel, aligning with the “post” in the cabinet. 10) Place the end covers over the water bottles. 11) Plug cordset into interlock receptacle on back of unit. 12) Plug cordset into wall receptacle. Humidifier is now ready for use. CONTROLS (Models 497 800, 497 300, 496 800, 447 401, 447 301, 427 300) FAN SPEED 13) Open control panel door by lifting with your finger under the finger tab. Depending on which model you have, you will have a choice of two, three, four or variable fan speeds allowing you to use a low setting for the most quiet operation or a high setting for maximum output. HUMIDITY SETTING 14) All models have an automatic humidistat. The humidistat will turn the humidifier on when the relative humidity in your home is below the humidistat setting and will turn the humidifier off when the relative humidity reaches the humidistat setting. For initial operation set the humidistat in the "comfort zone" and adjust up or down from there to achieve the desired humidity level. Turning the variablespeed humidistat all the way counterclockwise will turn the unit off regardless of the relative humidity. This must be turned on again before the unit will work. REFILL LIGHTS 15) The “Refill Bottles” indicator will light, and the motor will turn off when the bottles are empty. The right bottle will empty first, then the left bottle. If the “Refill Light” comes on, and the right bottle has not emptied, raise the right side of the unit until it is level. CONTROLS (Model 4D7 800, 4D6 800 Digital Humidistat) 16) Models 4D6 800 and 4D7 800 are equipped with a multi-speed fan control switch. Use the lower settings for quiet operation, and the higher settings for maximum output. These models have a digital humidistat with LCD display. The room’s Relative Humidity (% RH) is displayed at the top and the desired humidity level is displayed at the bottom. The desired humidity level can be manually adjusted between 30 and 90%, using the “Set Humidity” button. 45% RH is the suggested initial setting. 17) The automatic humidistat will turn the humidifier...
Other models in this manual:Humidifiers - 447 301 (321.06 kb)
Humidifiers - 427 300 (321.06 kb)
Humidifiers - 496 800 (321.06 kb)
Humidifiers - 497 300 (321.06 kb)