Votes - 0, Average rating: 0
(
)
)
|
manual abstract
Then wait until the remaining water has evaporated from the soleplate of the iron. 3. anti-calc The “anti-calc” cartridge has been designed to reduce the build-up of scale produced during steam ironing, helping to extend the useful life of your iron. Nevertheless the “anti-calc” cartridge cannot remove all of the scale that is produced naturally over time. "secure" auto shut-off function 8 (model dependent) The "secure" auto shut-off function switches off the iron when it is left unattended, thus increasing security and saving energy. After plugging in the appliance, this function will be inactive for the first two minutes in order to give the appliance time to reach the set temperature. Alter such time, if the iron is not moved for 8 minutes while in the upright position or 30 seconds while resting on its soleplate or on its side, then the safety circuit will switch the appliance off automatically and the pilot light will start flashing. To reconnect the iron, just move it about gently. Anti-drip system 9 (model dependent) If the temperature is set too low, the steam is automatically switched off to avoid dripping. Storing 10 Set the steam regulator to the position. Store the iron in upright position. Cleaning 11 Do not use descaling agents (unless they have been advised by Bosch), they can damage the appliance. Never use sharp objects or abrasive products to clean the soleplate or any other part of the appliance. To keep the soleplate in good condition, do not allow it to come into contact with metal objects. Do not use scourers or chemical products to clean the soleplate. Fabric-protection soleplate cover / blanket (Depending on the model) The fabric-protection is used for steam-ironing delicate garments at maximum temperature without damaging them. Use of the protector also does away with the need for a cloth to prevent shine on dark materials. It is advisable to first iron a small section on the inside of the garment to see if it is suitable. Tips to help you save energy Steam production consumes the most energy. To help minimise the energy used, follow the advice below: • Start by ironing the fabrics that require the lowest ironing temperature. Check the recommended ironing temperature in the label on the garment. • Regulate the steam according to the selected ironing temperature, following the instructions in this manual. • Only use steam if necessary. If possible, use the spray function instead. • Try to Iron the fabrics while they are still damp and reduce the steam setting. Steam will be generated from the fabrics rather than the iron. If you tumble dry your fabrics before ironing them, set the tumble drier on the ‘iron dry’ programme. • If the fabrics are damp enough, turn off the steam regulator completely. • Stand the iron upright during pauses. Resting it horizontally with the steam regulator on generates wasted steam. Tips on disposing of a used appliance Before throwing a used appliance away, you should first make it noticeably in...
Other models in this manual:Irons - TDA46MOVE1/01 (719.57 kb)
Irons - TDA46MOVE2/01 (719.57 kb)
Irons - TDA46MOVE3/01 (719.57 kb)