Votes - 0, Average rating: 0
(
)
)
|
manual abstract
• The temperature of the sole plate and the boiler are regulated automatically. Pilot lamps 6 and 11 come on and go off periodically. This is normal. • When indicator (7) lights up due to a lack of water in the boiler, the boiler will have to be refilled (see section on How to refill the boiler during use). ADJUSTING THE STEAM FLOW (Mod. PL1382) The steam flow setting can be adjusted to suit the type of ironing. Turning the control knob to the left reduces the steam flow, whereas maximum steam flow can be achieved by turning it to the right. (Fig. 6) IRONING WITH STEAM After having carried out this operation, switch the appliance on. • Press push-button (8) on the iron to get a jet of steam. The steam stops as soon as the button is released. Fig. 5. Use of steam below the 2 point "••" thermostat setting is not recommended. CREASE REMOVAL IN VERTICAL • Turn the temperature regulator (12) to the “MA X” position and wait until it reaches temperature. • Hang the garment on a hanger and place the iron some 10-20 cm away. Never iron a garment if somebody is wearing it at the time (Fig.6) • Press the steam production trigger for as long as considered necessar y, a continuous jet of steam will be produced. SAFETY DEVICES This appliance is fitted with the following safety devices: - On the iron • A safety trip that stops it from overheating - On the boiler: • A safety valve • A safety trip that stops it from overheating. STORING • Unplug the appliance • Wipe the sole plate down with a damp cloth while it is still warm, after each use. • Place the iron on the Iron-rest platform. • Gather up the mains supply connection cable and insert it into the left-hand compartment. Fig. 8 • Gather up the iron-boiler connection cable and insert it into the right-hand compartment. Fig.8 • It is not necessar y to empty the boiler out after each use. MAINTENANCE AND CLEANING Avoid scratching the iron; do not pass it over hard surfaces. Traces of starch or sprays can be removed from the base with damp cotton wool or a non abrasive cleaning product. The boiler tank is made of stainless steel. Due to the characteristics of this material less lime scale is produced. It is advisable to rinse the boiler out regularly with clean water so as to remove any traces of lime, following the appliance’s safety rules; being unplugged and cold. The outer surface of both the iron and the boiler can be cleaned down with a damp cloth, without the use of abrasive agents or solvents. REPAIRS Should the cable and/or the appliance become defective do not hesitate in taking it to an Authorised Technical Service Centre. ADVICE ON DISPOSAL: Our goods come in optimized packaging. This basically consists in using non-contaminating materials which should be handed over to the local waste disposal ser vice as secondary raw materials. Your local town council can give you information about how to dispose of obsolete appliances. MOST COMMON PROBLEMS PROBLEM CAUSES SOLUTION The iron does not heat up and the...
Other models in this manual:Irons - PL1381/06 (701.08 kb)
Irons - PL1382/04 (701.08 kb)