Votes - 2, Average rating: 4 ( )

Manafacture: GE File size: 105.38 kb File name: Language of manual:

Turn iron upside down until Water Tank Opening is parallel with sink. Water will run out of water tank opening. 2. After iron has completely cooled, fully retract cord into iron and store in an upright position. Do not store iron laying flat on soleplate. Soleplate 1. Never iron over zippers, pins, metal rivets, or snaps, as these may scratch the soleplate. 2. To clean occasional build-up on the soleplate, wipe with a sudsy cloth. Do not use abrasive cleansers or metal scouring pads. 3. Always store iron upright in the heel rest position. Self-Clean To keep the steam vents clear of any build-up, follow these instructions each time you iron using steam. 1. Set Fabric Setting Indicator to OFF ( O ). Fill iron with water to 1.2 of its maximum capacity. 2. Set Adjustable Steam to Dry Iron position. Set Fabric Setting Indicator to Linen setting and let iron heat for 2 minutes. 3. Set Fabric Setting Indicator to OFF ( O ). Unplug iron and hold over a sink with soleplate facing down. 4. Press and hold the Self Clean Button. Boiling water and steam will flow out of steam vents. Allow all water to drain from iron. 5. Gently move iron front to back to allow water to clean entire soleplate area. 6. If water still remains inside of soleplate, reheat iron as indicated in Step 2. Boiling water and steam could still flow out of steam vents. FEATURES (on selected models) Blast of Steam and Spray Buttons Push Steam Button for an extra blast of steam. Push Spray Button to release a fine spray of water for difficult wrinkles in cotton or linen. Spray Steam 5 840173100 Ev02 12/11/07 1:11 PM Page 6 FEATURES (cont.) Automatic Shutoff Status Indicator If the iron is an Automatic Shutoff model, the light comes on when iron is first plugged in. Auto Shutoff Status Indicator After 1 hour the iron will shutoff and the light will go out. Press the Temperature Selector to turn the iron back on for another hour of ironing. Quick Off Press and hold the Temperature Selector for three seconds to turn the iron off quickly. Temperature Selector Retractable Cord 1. Pull cord to desired length. Do not 2. To store cord, press and hold Cord unwind cord beyond colored tape Release Button while guiding cord into indicator on cord. storage area. CAUTION: Hold plug while retracting cord. Do not let cord retract freely. Cord may jam on reel or loose cord may whip back and forth and could cause injury. Vertical Steam 1. Follow Steps 1 through 3 in “To Steam Iron.” 2. Hang garment in a location that is not susceptible to damage from heat or moisture. Do not hang in front of wallpaper, window, or mirror. 3. Hold iron about 6 inches away from garment. Press and release Blast Button to steam out wrinkles. Do not press Blast Button more than once every 2 seconds. 4. To turn iron off, turn Adjustable Steam to Dry Iron. Set Fabric Setting Indicator to OFF ( O ). Unplug iron. 5. Empty water from iron following directions in “Caring for Your Iron.” NOTE: Do not allow hot soleplate to touch delicate garments. 6 840173100 Ev02 12/11/07 1:11 PM Page 7 TROUBLESHOOTING PROBLEM THINGS TO CHECK Iron won’t heat. • Is the iron plugged in and the outlet working? Check the outlet by plugging in a lamp. • Is the Temperature Control turned to a fabric setting? • If auto shutoff model, is light on? If not, push Reset Button. Water is leaking out of the iron. • Do not overfill the water tank. • If steam ironing, is Adjustable Steam in a steam position, Fabric Setting Indicator in the steam range and did the iron have enough time to preheat? • If dry ironing, make sure the Adjustable Steam is in the DRY IRON position. Iron won’t steam. • Check the water level. • Is the Adjustable Steam Switch in the STEAM position? • Has the iron had enough time to preheat? Iron leaves spots on clothing. • ALWAYS empty the water tank of the iron after using. Water left in the tank may discolor clothing and soleplate. Retractable cord will not unwind (on select models). • Rewind a small amount of cord then fully depress the Cord Release Button and pull the cord to desired length. 7 840173100 Ev02 12/11/07 1:11 PM Page 8 CUSTOMER SERVICE If you have a claim under this warranty, please call our Customer Assistance Number. For faster service please have model, series, and type numbers ready for operator to assist you. These numbers can be found on the bottom of your appliance. MODEL: ________________ TYPE: _________________ SERIES: ________________ Customer Assistance Number 1-877-207-0923 (US) or 1-877-556-0973 (Canada) Keep these numbers for future reference! For more information, please visit us at Two-Year Limited Warranty What does your warranty cover? • Any defect in material or workmanship. For how long after the original purchase? • Two years. What will we do? • Provide you with a new one. • For those items still under warranty but no longer available, WAL-MART reserves the right to replace with a similar GE branded product of equal or greater value. How do you make a warr...

Download now

Please, enter two numbers from picture: