Votes - 4, Average rating: 4 ( )

Manafacture: Groupe SEB USA - T-FAL File size: 258 kb File name: Language of manual:

• If the electrical cord becomes damaged, it must be immediately replaced by an Approved Service Centre to avoid any danger. • The appliance should not be used if it has fallen, if it has obvious damage, if it leaks or has functional anomalies. Never dismantle your appliance : have it inspected by an Approved Service Centre, so as to avoid any danger. • Never immerse your iron in water ! • Do not unplug your appliance by pulling on the cord.Always unplug your appliance: before filling or rinsing the reservoir, before cleaning it, after each use. • Never leave the appliance unattended when it is connected to a power source; if it has not cooled down for approximately 1 hour. • Your appliance gives off steam, which may cause burns, especially when you are iro- ning on a corner of your ironing board. Never direct the steam towards people or animals. • Your iron should be used and placed on a stable surface.When you put your iron onto its iron rest, make sure that the surface on which you put it is stable. • This product has been designed solely for domestic use.Any inappropriate use or use contrary to the instructions releases the brand from all responsibility and ren- ders the guarantee invalid. ENVIRONNEMENT PROTECTION FIRST ! ppliance contains valuable materials which can be recovered or recycled. .Leave it at a collection point. 4- STORING YOUR IRON - Unplug the iron and wait for the soleplate to cool down. - Empty the water tank and set the steam control to DRY.A little water may remain in the tank. -Wind the cord not too tightly around the heel at the back of the iron. - Store the iron on its heel. 2- DRY IRONING - Choose your ironing program. - Set the steam control to DRY (see diagram A). -You may start ironing when the thermostat light goes out. • CLEANING THE ANTI-CALC VALVE (Once per month) : - Unplug your iron and empty the water tank. -To remove the anti-calc valve, select program 8, press the release button (P) and pull the valve upwards. NEVER TOUCH THE END OF THE VALVE. - Soak the valve in a cup of white spirit vinegar or plain lemon juice for 4 hours (Q). - Rinse the valve under running water. - Replace the anti-calc valve. THE IRON WILL NOT FUNCTION WITHOUT THE ANTI-CALC VALVE. 3- CARING FOR YOUR IRON BE CAREFUL ! Unplug your iron and let it cool down before cleaning it. • SELF-CLEANING : In order to extend the life of your iron, use the Self-Cleaning function once a month. - Set the steam control to steam ( ) -Allow your iron to heat up with the tank full and standing on its heel (on program 8). -When the thermostat light goes out, unplug the iron and hold it in a horizontal position, over a sink. - Remove the anti-calc valve. - Shake the iron gently, over the sink, until some of the water in the water tank (with the impurities) has flowed out through the soleplate. -At the end of the operation, push the anti-calc valve back into position. -Turn the iron back on for 2 minutes, setting it on its heel, to dry...

Download now

Please, enter two numbers from picture: