|
Other manuals for this model:
manual abstract
McDATA® 4Gb SAN Switch
Overview
The McDATA® 4Gb SAN Switch for HP p-Class BladeSystem
for HP p-Class BladeSystem
(referred to as the SAN Switch) provides Fibre Channel (FC) switch
connectivity for all p-Class blade servers offering FC options. FC
quick setup instructions
port connectivity is integrated into the HP p-Class BladeSystem
enclosure for all models except the BL40p which can connect via an
external port of the 4 Gb SAN Switch.
Kit contents
• One set of HP McDATA 4Gb SAN Switch for HP p-Class
BladeSystem quick setup instructions
• One SAN Switch
• One HP ProLiant BL p-Class FC Signal Conditioning Card
Read instructions completely before beginning the installation
• Two 4Gb small form-factor pluggable (SFP) optical transceivers
procedure.
Warnings and cautions
WARNING! Installation of the HP ProLiant BL p-Class FC
Signal Conditioning Cards should be performed by
individuals who are both qualified to service computer equipment
and trained in the dangers associated with products capable of
producing hazardous energy levels.
WARNING! To reduce the risk of personal injury from hot
surfaces, allow the system components to cool before
touching them.
CAUTION: Properly ground yourself before beginning any
installation procedure. Electrostatic discharge can damage
electronic components.
Printed on at least 50% total recycled fiber with at least 10%
post-consumer paper
Installation guidelines
© Copyright 2005 Hewlet -Packard Development Company, L.P.
© Copyright 2005 McDATA Corporation.
Observe the fol owing guidelines during installation:
© Copyright 2005. This software includes technology under a license
1. Install the FC signal conditioning cards into the HP p-Class
from QLogic Corporation. All rights reserved.
BladeSystem Interconnect Switch.
McDATA® is the Registered Trademark of McDATA Corporation.
2. Install the Interconnect switch into one of the interconnect bays,
Second edition July 2005
which are the left-most (side A) and right-most (side B) bays on
the front side of the server blade enclosure.
Product names mentioned herein may be trademarks of their
respective companies as reflected by an associated footnote.The
3. Install the SAN Switch into the top left-most or top right-most bay
information in this document is subject to change without notice.
on the rear side of the blade enclosure corresponding to the
installed Interconnect switch.
Printed in the US.
4. Install the included small form-factor pluggable optical
www.hp.com
transceivers (SFP modules) into the appropriate FC ports of the
SAN Switch.
Additional information
For additional information about Storage Area Network (SAN)
connectivity, refer to the SAN Design Reference Guide located at
http://h18000.www1.hp.com/products/storageworks/san/
documentation.html. Additional documentation related to the
*A8001-90002*
McDATA 4Gb SAN Switch is available on the following HP web
site: http://h18006.www1.hp.com/storage/saninfrastructure.html
A8001-90002
Page 1
McDATA 4Gb SAN Switch for HP p-Class BladeSystem quick setup instructions
...