Manafacture: HP File size: 205.69 kb File name: Language of manual:

Free link for this manual available at the bottom of the page

Page Additions
1
Replacing a failed hard drive
Follow these steps to install the hot-pluggable hard drive into the system:
1. Remove the NAS 1200s front bezel.
a.
Locate the two bezel latches found on the side of the bezel. Pull the latches outward.
b.
Pull the front bezel away from the unit.
2. Remove a hard drive from the disk enclosure before installing a new hard drive.
a.
Press the ejector button and pivot the lever to full open position.
b.
Pull the drive from the disk enclosure.
3. Slide the replacement drive into the disk enclosure.
4. The ejector lever must be in the full open position while installing to ensure a correct latch.
When the drive has been fully inserted, close the ejector lever.
5. With the system powered on, open Logical Disk Manager (LDM) and follow these steps to
reactivate the disk.
a.
Open the Run applet from the Start menu and type diskmgmt.msc.
b.
After the failed drive is replaced in the NAS 1200s, the disk is detected in LDM as
Unknown and must be initialized. If the disk is already detected as a Basic disk,
proceed to step 5c. Right-click the Unknown disk and select Write Signature.
c.
The new hard disk is now detected as a Basic disk. Upgrade the disk to Dynamic by
right-clicking the disk and selecting Upgrade to Dynamic Disk as shown in Figure 8.
NAS 1200s Instal ation Guide Addendum
1
Addendum Pg

---

...

Other models in this manual:
Media Storage - HP StorageWorks NAS 1200s Model 320 GB (205.69 kb)
Media Storage - HP StorageWorks NAS 1200s Model 640 GB (205.69 kb)

Download now

Please, enter two numbers from picture: