The message box has two buttons; Retry and Cancel. This may occur if you have ordered the HP
3PAR StoreServ File Controller v2 systems with optional network adapters and have cabled ports
on those adapters to your network infrastructure.
As shown in the Quick Start Guide, there is one network cable that must run between the Port 4
adapters on each of the two nodes. Keep this network cable in place, as well as the network
cable to the iLO port, but disconnect all other network cables on the system where you received
the error message. Then click Retry. You may reconnect the cables later after the second node is
discovered.
•
The Create Volumes link in the Storage Configuration section launches the Virtual Disk wizard.
While creating a new virtual disk, if you select Create a volume when this wizard closes, the
Create Volume wizard is auto-launched after the virtual disk is created.
•
On a non-English HP 3PAR StoreServ File Controller v2 standalone system, the ICT may not display
the Set local administrator password link.
Change the password using one of the following methods:
◦
Connect to the server using iLO. From the iLO menu, select Keyboard→CTRL-ALT-DEL. The
option to change the password is displayed.
◦
Log in to the server. Navigate to Control Panel→User Accounts. Select Change account type
and then select Administrator. Select Change the password and enter the new password
credentials. Click Change password.
Network Configuration Tool
•
If you select Do not configure network interface VLAN identifiers now after assigning VLAN IDs
to Teams or adapters, the assigned IDs are not removed.
For all Teams and adapters, you must navigate through each VLAN page and select Do not add
a VLAN ID to this Team.
•
If you assign the same subnet mask to more than one network interface on the same server, it
might have unexpected results.
HP recommends that you must not configure more than one network interface with the same subnet
mask on a server.
•
You must select the interfaces in the Interface Selection wizard before the interfaces can be added
to a Team. However, NCT (Network Configuration Tool) does not display any message regarding
this.
HP recommends that you always select the interfaces on the Interface Selection page so that the
interfaces are available to the Team in the Team Creation page.
•
When discovery is in progress on clustered systems and if you click the remote node in the tree
view (the left navigation pane), then after the discovery is complete the tree view is empty.
To view the remote node tree view, click the local node and then click the remote node.
•
When assigning a range of VLAN IDs to a Team, if the incremental value is blank, then NCT
proceeds to the next page without any prompts, even if:
◦
There are invalid inputs.
◦
No VLAN ID is assigned to that particular Team.
Ensure that you specify the incremental value whenever you assign a range of VLAN IDs to a
Team.
Workarounds
7

---

...

Other models in this manual:
Media Storage - HP 3PAR StoreServ File Controller v2 Storage (180.4 kb)