Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
Media Storage - HP SB40c Storage Blade (1.88 mb)
Media Storage - HP SB40c Storage Blade (283.85 kb)
manual abstract
Half-height device bay
documentation that ships with the mezzanine card and
numbering
the server blade documentation.
•
Install the coupler plate on the SB40c.
•
Install the SB40c in any device bay on the lower row of
the enclosure (9 through 16).
•
If the SB40c is installed in an odd-numbered bay, install
the partner server blade in the adjacent even-numbered
bay to the right.
•
If the SB40c is installed in an even-numbered bay, install
the partner server blade in the adjacent odd-numbered
bay to the left.
•
When installing the SB40c with a full-height server
blade, a half-height server blade can be installed in the
empty bay above the SB40c. This server blade cannot
be partnered with the SB40c.
Installing a storage blade
Installation guidelines
CAUTION: To prevent improper cooling and thermal
damage, do not operate the server blade or the
Observe the following guidelines when installing the SB40c:
enclosure unless all hard drive and device bays are
•
An SB40c supports one partner server blade, and a
populated with either a component or a blank.
partner server blade supports one SB40c.
1. Install the hard drives.
•
Install hard drives in the SB40c before installing the
2. Remove the blank.
SB40c in the enclosure.
•
Be sure that the partner server blade is powered down
before installing the SB40c.
Onboard Administrator is used to configure the enclosure and
the SB40c. To function with the SB40c, Onboard
Administrator version 1.10 or later is required.
Additional guidelines for installation with a
half-height partner server blade
When installing the SB40c with a half-height server blade,
observe the following additional guidelines:
•
Install the SB40c in any device bay.
•
If the SB40c is installed in an odd-numbered bay, install
the partner server blade in the adjacent even-numbered
3. Remove the enclosure connector cover.
bay to the right.
•
If the SB40c is installed in an even-numbered bay, install
the partner server blade in the adjacent odd-numbered
bay to the left.
Additional guidelines for installation with a
full-height partner server blade
When installing the SB40c with a full-height server blade,
observe the following additional guidelines:
•
Remove the device bay shelf.
•
Install a HP PCIe Mezzanine Pass-Thru Card in
mezzanine 3 connector in the server blade. See the
...Other models in this manual:
Media Storage - HP SB40c Storage Blade with (4) 300GB Drive Bundle (495.24 kb)
Media Storage - HP SB40c with Virtual SAN Appliance Software Bundle (495.24 kb)