Votes - 3, Average rating: 4 ( )

Manafacture: Bloomfield File size: 214.93 kb File name: 277d220e-68fb-4003-90f7-f1e7348d2277.pdf Language of manual:

This manual and all supplied instructions, diagrams, schematics, parts breakdown illustrations, notices and labels must remain with the appliance if it is sold or moved to another location. This appliance is made in the USA. Unless otherwise noted, this appliance has American sizes on all hardware. This unit complies with NSF standard 4 only if maintained and operated per the instructions in this manual. This unit is Underwriters Laboratory listed under E6070. WARNING: ELECTRIC SHOCK HAZARD All servicing requiring access to non-insulated electrical components must be performed by a qualified technician. DO NOT open any access panel that requires the use of tools. Failure to follow this warning can result in severe electrical shock. CAUTION: RISK OF DAMAGE DO NOT connect and/or energize this appliance until all installation instructions are read and fol- lowed. Damage to the appliance will result if these instructions are not followed. PRECAUTIONS AND GENERAL INFORMATION AGENCY APPROVAL INFORMATION STD 4 E6070 201 p/n 40091 OpM T-4C and BT-4C Toaster PRECAUTIONS AND GENERAL INFORMATION AGENCY APPROVAL INFORMATION STD 4 E6070 201 p/n 40091 OpM T-4C and BT-4C Toaster 3 INSTALLATION INSTALLATION NOTE: DO NOT discard the carton or other packing materials until you have inspected the appliance for hidden damage and tested it for proper operation. Refer to SHIPPING DAMAGE CLAIM PROCEDURE on the inside front cover of this manual. DO NOT lift or carry the toaster by the bread slots. This will damage the heating elements Lift and carry by the carrying handles only. CAUTION: ELECTRIC SHOCK HAZARD The ground prong of the power cord is part of a system designed to protect you from electric shock in the event of internal damage to the appliance. NEVER CUT OFF THE GROUND PRONG (large round prong). NEVER TWIST A PRONG TO FIT AN EXISTING RECEPTACLE. If circuit or receptacle does not match the toaster plug, contact a licensed electrician to install an electrical receptacle appropriate to the voltage and amperage requirements of the toaster. IMPORTANT: Damage due to being plugged into the wrong voltage or phase is NOT covered by warranty UNPACKING & INSPECTION Carefully remove the toaster from the carton. Remove all protective plastic film, packing materials and accessories from the toaster before plugging the toaster into electrical power or otherwise performing any installation procedure. Carefully read all instructions in this manual and the Installation Instruction Sheet packed with the toaster before starting any installation. Read and understand all labels and diagrams attached to the toaster. Carefully account for all components and accessories before discarding packing materials. Store all accessories in a convenient place for later use. SETUP Setup the toaster only on a firm level surface. Non-combustible material (e.g. metal, terrazzo) is recommended. ELECTRICAL Refer to the nameplate. Verify the electrical service power. Voltage and phase must match the nameplate specifications. Plugging the toaster into the wrong voltage can severely damage the equipment or cause noticeably decreased performance. Your appliance is equipped with a grounded electric power cord. This cord must be plugged into a properly grounded electrical receptacle. T-4C Toasters are equipped with a 4 foot cord with grounded NEMA 6-15P plug. This cord must be plugged into a 208 or 240 volt, 15 amp circuit with a properly installed and grounded NEMA 6-15R receptacle. Refer to toaster nameplate for proper voltage. T-4C 15A Toasters and BT-4C Bagel Toasters are equipped with a 4 foot cord with grounded NEMA 5-15P plug. This cord must be plugged into a 120 volt, 15 amp circuit with a properly installed and grounded NEMA 5-15R receptacle. 201 p/n 40091 OpM T-4C and BT-4C Toaster 4 OPERATION OPERATION 201 p/n 40091 OpM T-4C and BT-4C Toaster GENERAL OPERATIONAL NOTES Carefully read the description of the toaster operation on the specification sheet. DO NOT attempt to perform any maintenance or service, or attempt to unjamb a slice of toast unless the toaster is unplugged from electrical power. DO unplug the toaster from electrical power before cleaning, servicing or unjamming. DO NOT use sharp objects or metal implements to unjamb a slice of toast. DO use a plastic spatula inserted along the bread guides, away from the elements, to remove toast that is jammed. DO NOT lift or carry the toaster by the bread slots. This will damage the elements. DO carry the toaster by the carry handles. OPERATION Turn the darkness control knobs to the desired toast color. The knobs may be rotated to the light position (fully counter-clockwise for very little color) to the dark position (fully clock-wise for dark brown). There are an infinite number of settings between these two extremes. Each knob controls one pair of bread slots. Experiment with your normal bread product and adjust the darkness control knobs to the desired toast color. Place one to four bread slices in th...

Download now

Please, enter two numbers from picture: