Votes - 4, Average rating: 4.3
(
)
)
|
manual abstract
defined by the store) by a simple depression without any numeric entry (Total Function only). AT/TL Cash Amount Tender/Total Key: Used to finalize a sale as cash by depressing with a prior tendered amount entry (Tender Function) or by a simple depression without any numeric entry (Total Function). -12- E01-11074 10. Installing the Paper Roll Turn the Control Lock to the REG1 position using a Control Key. Hold the paper roll so that the paper end will be fed from the bottom. EOM1Q74 Place the paper roll in the paper pocket. Insert the paper end into the Paper Inlet located on the rear side of the printer, and hold down the [FEED] key on the keyboard until the paper end comes out of the outlet. If the printer is used for journal, fold the top end of the paper and insert the folded end into the slit of the Take-up Reel Shaft. Then wind the paper two or three times, set the reel to the holder, and hold down the [FEED] key for a while to tense the paper. If the printer is used for receipts, do not wind the paper end around the Journal Take-up Reel. - 14- E01-11074 If the printer is used for journal, simply attach the Paper Cover. The Receipt Outlet is used as Journal Window. If the printer is used for receipts, attach the Paper Cover with the paper end coming out of the Receipt Outlet located on the Paper Cover. 15- EO1-11074 11. Programming The time and date should be adjusted and such data as status of each department, percent rate, etc. should be programmed before starting sale entries. Printing occurs as programming is proceeded. • The programmed data will be retained by dry batteries even if the power of the machine is turned OFF or a power failure occurs. • Turn the Control Lock to the Z position before starting REG2 ^^REGi any programming operation (Time Setting and Date Setting can be operated in either X or 2 position). • Key indications in the operation patterns in this manual: I I .....Entry through a Numeric Key □ ..... Function Key depression Time Setting (Control Lock: X or Z) The 24-hour system (military time} is used for time setting. □□□□ — m (No printing occurs. Indicates the set result in the Hour Minute display.) (00 to 23) (00 to 59) Date Setting (Control Lock: X or Z) i ► X I (No printing occurs. Indicates the set r --vT— — u—1 result in the display.) Month Day Year ' (01 to 12) (01 to 31) (93, 94, etc.) NOTE: The dale entry order above shows the initial set order. The entry order of Day-Month- Year or Year-Month-Daycanbe selected instead of Month-Day-Year by the Date Entry Order option to be described later. Sample Programming Operations To set the time to 1:05 pm and the date to August 5.1993: Value of Display seconds EMEU] □ (Time Setting) to clear the time display mUMMEIUE] (Date Setting) n I _ nr nn U I U O UU nnn u