The hour value will blink. (D Press the Adjust button to set the correct hour. Set the minute. * © Press the Set button. The minute value will blink. (2) Press the Adjust button repeatedly to set the correct minute. Press the Set button at the exact time the minute changes to finalize the date/time setting. Press the On/Off Start button to switch off the power. 6 7 When the date or time are blinking, the clock is stopped. During leap years, 3/1 will be displayed on February 29.
Keeping an accurate record of your blood pressure will help your doctor diagnose and possibly prevent any health problems in the future. Basic of Blood Pressure Your heart acts like a pump, sending blood surging through your blood vessels each time it contracts. Blood pressure is the pressure exerted by blood pumped from the heart on the walls of blood vessels. Systolic pressure is the pressure exerted when the heart contracts and pumps blood into the arteries. Diastolic pressure is the pressu
(For storing measurement values, see p. 17.) • The pulse rate value is the beats per minute calculated based on the pulse rate during measurement. 3. To switch off the blood pressure monitor, press the On/Off Start button. • If you forget to switch it off, the blood pressure monitor will switch off automatically after approximately 5 minutes. SY^Dl* mmHg DIASTOLIC mmHg_ mss V 15 Flash warning system for hypertensive readings If the measured values fall within the hypertension range, the
EW3006 Modelo No. EW3006 Before operating this device, please read these instructions completely and save this manual for future use. Antes de usar este dispositivo, lea completamente estas instrucciones y guarde este manual para utilizarlo como referencia en el futuro. Panasonic Oscillometric Diagnostec™ Wrist Blood Pressure Monitor Model EW3006 Is a device Intended to measure systolic and diastolic blood pressure and pulse rate of an adult Individual by using a pressurized cuff on the left
• You unconsciously bent your elbow. • The upper arm became very tense. • You moved your arm. • Etc. Return to the proper posture. o Lit Beep beep (short buzzer sounds) A movement which will cause large differences in measurement values occurred. • Body movement was large. • Body movement occurred several times. • Arm movement was large. Remeasure (Remeasure mark E is shown.) • It will also be lit in the following cases: • Pressure cuff tape fastener became unfastened. • Tube came out. • Etc. (
We recommend three measurements a day. First··· Upon Waking (Because, with almost no influence from body movements, the blood pressure is closest to that at night.) Second··· Before Lunch (Because, with no influence from the meal, it provides blood pressure values close to the highest of the day.) Third··· At Bedtime (So as to obtain data close to your average blood pressure values during the day.) This way, by taking measurements morning, noon and night, you can use the unit to learn the patter
2. Press the Memory/Recall button. • The average readings of all recorded measurements are displayed. • When readings from 90 measurements have been saved the average of the readings from all 90 measurements will be displayed. (If there is only 1 measurement recorded, mark will not be displayed.) • The mark will be displayed. • Blood pressure indicator will be lit up for approximately 6 seconds. 3. Press the Memory/Recall button to display readings starting with from the most recent measurement.
4-a). Adjust the month. Press the Adjust button v?; to adjust the number of the month (Fig. 4-b). Adjust the day. (1) Press the Set button 'f; and the number for the day will flash (Fig. 4-c). (2) Press the Adjust button ■,?; to adjust the number of the day. Adjust the hour. (1) Press the Set button (i> and the number for the hour will flash (Fig. 4-d). (2) Press the Adjust button ¡2; to adjust the number of the hour. Adjust the minutes. (1) Press the Set button (1> and the number for
Positioning the Pressure Cuff CAUTIONS: • Do not use the unit for any purpose other than measuring blood pressure. Also, do not use the unit in conjunction with other devices. Improper use may cause a malfunction or personal injury. • Keep the unit out of the reach of children. Fig. 5-a 1. Remove your watch and any jewelry from First wrinkle line of your left hand. 2. Wrapping the cuff around the wrist and securing with hook-and-loop fastener. Leave main unit at the distance of 2 cm (3/4") from
1. Press the Memory/Recall button. • The average readings of all recorded measurements are displayed. • The mark will be displayed (Fig. 10-a). • When, for example, readings from 21 measurements (After approx. have been saved the average of the readings from 21 one second.) measurements will be displayed. Fig. 10-b 2. Press the Memory/Recall button to display readings starting with from the most recent measurement. • Each time the Memory/Recall button is pressed readings are displayed in order o