Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  
downloaded: 2   File size: 229 kb   Manafacture: Dansons Group  
Category: Thermostat
@name

You may hit the START button if you are ready with a full hopper of fuel. * The thermostat is available separately from the stove. The 3 modes are as follows: When the red FEED RATE lights 3 and 4 flash, that is the High/Low Thermostat Cycle (optional *). 1When the red FEED RATE lights 1 and 2 flash, that is the On/Off Thermostat Cycle (optional *). 2When the red FEED RATE lights 1 and 4 flash, that is the manual function. 3IMPORTANT: PLEASE READ BEFORE STARTING YOUR STOVE The controller on your

downloaded: 6   File size: 229 kb   Manafacture: Dansons Group  
Category: Thermostat
@name

Connect the 2 wires at your wall thermostat to their terminals. Ensure the wires are firmly connected 10. Reinstall the 9 pin wire harness to the 9 pin plug now found on the thermostat module 11. Reinstall the control board and the slotted rear access panels 12. Plug in the stove and you are ready to operate with your thermostat asdesred IMPORTANT: PLEASE READ BEFORE STARTING YOUR STOVE The controller on your stove has been fitted with memory. Should you have a power outage or blip, the unit wil

downloaded: 9   File size: 229 kb   Manafacture: Dansons Group  
Category: Thermostat
@name

Unplug the stove’s power cord from the wall outlet 2. Remove the 6 x 1/4” hex screws from the slotted back access panel 3. Unscrew the control board from the side of the heater (2 x 1/4” hex screws) 4. Unplug the 9 pin wire harness from the back of the board 5. Install the thermostat module by plugging it into the 9 pin plug on the back of the control board 6. Locate the thermostat terminal block marked T’STAT INPUT, found on the back of the module 7. Be sure to run the thermostat wires through





Category