Votes - 0, Average rating: 0
(
)
)
|
manual abstract
Boiling and dispensing water
Energy saving timer
98
Energy
10hrs Saving
When the unit will not be used for a short time, such as
Select
60 6 hrs Timer
when you are sleeping or when you go out for the day,
by setting this timer you can cut your electricity bill.
Cleaning
●Select either the "6 hrs" or "10 hrs" timer, depending on how
Lights
long you will sleep or be away from your house.
Press the Select key to select the "6 hrs" or "10 hrs" timer.
Flashing ⇒ Lights solidly Goes out
⇒
When the timer is started, the indicator lamp will light, and the
⇒
temperature of hot water will drop automatically (to about 60¡C).
Six or 10 hours later, the timer will be reset. After the water is
98
Energy
10hrs
brought up to boiling temperature again, it will be kept warm at
Saving
60 6 hrs Timer
about 98¡C.
Cleaning
How to use the about 60¡C keep-warm function
Please cool down the temperature of the baby milk or
mix with cool boiled water before you give it to baby.
Press the Select key to select "60".
(The 60 keep-warm indicator lamp will flash.)
The temperature of hot water will drop to about 60¡C.
98
Energy
10hrs
(When the temperature reaches about 60¡C, the indicator lamp
Saving
Select
will change to steadily lit.)
60 6 hrs Timer
Time required to reach about 60¡C
Cleaning
About 3 - 4 hours (Full pot/Room temperature: 20¡C)
Flashing
Precautions when the energy saving timer is used or
when the about 60¡C keep-warm function is selected
●When the power is restored after a power failure, the timer
will be set to about 98¡C.
●When the temperature of hot water has dropped because
water was added, the water will be brought up to boiling
temperature.
●The keep-warm temperature can be changed while the
water is being boiled.
●The energy saving timer can be set while the water is being
boiled. In this case, even though the timer has been started
the water will be brought to boiling temperature.
●The minimum water temperature is about 60¡C while the
energy saving timer is being used.
Helpful tips
●Do not use the unit near an open flame.
(The unit may become deformed.)
●Do not supply water directly from the tap.
(If the water overflows the pot and it enters the electrical parts
built into the main unit, it may cause a malfunction.)
●Do not leave water standing in the container.
(It may cause the container to corrode or smell.)
●Do not pour water out of the pot over the side where the
operation panel is located.
(Water infiltration may cause a malfunction.)
13
...Other models in this manual:
Thermo Pots - NCER30C (6.85 mb)