Votes - 2, Average rating: 4.5
(
)
)
|
manual abstract
• “ TV” will jump to TV. • “ VCR” will jump to last active VCR or DVD. Active VCR/DVD is defined as the mode that remains for a minimum of 5 seconds, or if a key is pressed in that mode. * The VOLUME and MUTE will jump to “TV” by default. When the volume is unlocked, all the devices will have their own volume. The AUDIO1/2 (Receiver, CD) modes will have their own volume even if Volume Lock is on TV, CABLE/SAT, VCR, or DVD. See “Using the volume lock feature” on page 21. **Press the REC button twice within 5 seconds to record each audio/video source. Index AppendixUsing the TV’sFeatures Setting upyour TV Using theRemote Control Connectingyour TV Introduction 19 Index AppendixUsing the TV’sSetting upUsing theConnectingIntroductionFeatures your TV Remote Control your TV Programming the remote control for use with your audio/video devices Device code setup 1. Refer to the Device code table on pages 22 – 23 to find the code for the brand of your device. If more than one number is listed, try each one separately until you find the one that works. 2. Press MODE until the Mode indicator of the device (CABLE/ SAT, VCR, DVD, AUDIO1, AUDIO2) lights up. 3. While holding down the RECALL button, press the Channel Number buttons to enter the four-digit code of your brand of device. If a valid code is entered, the mode indicator will blink twice. If an invalid code is entered, the mode indicator will blink one long blink. 4. Point the remote control at the ...
Other models in this manual:Televisions - 52HMX84 (3.43 mb)
Televisions - 52HMX84 (3.43 mb)
Televisions - 62HMX84 (3.43 mb)