Votes - 4, Average rating: 4.5
(
)
)
|
Other manuals for this model:
manual abstract
. Import from USB: Import channel list from USB. . Export to USB: Export channel list to USB. This function is available when USB is connected. Fine Tune Menu > Channel > Fine Tune (Analogue channels only) If the reception is clear, you do not have to fine tune the channel, as this is done automatically during the search and store operation. If the signal is weak or distorted, fine tune the channel manually. Scroll to the left or right until the image is clear. N Settings are applied to the channel you’re currently watching. N Fine tuned channels that have been saved are marked with an asterisk “*” on the right-hand side of the channel number in the channel banner. N To reset the fine-tuning, select the Reset. Edit Channel Number Menu > Channel > Edit Channel Number (Depending on the model) Edit the channel number by select the numbers. N This function may not be supported depending on the region. Crosstalk noise reduction Menu > Channel > Crosstalk noise reduction (Depending on the model) (Analogue channels only) This function reduces diagonal noise in the picture caused by signal crosstalk (interference). If your TV picture displays diagonal noise or distortion when you watch, turn on this function. Satellite System Menu > Channel > Satellite System Satellite System is available when Aerial is set to Satellite. Before running Auto Store, set Satellite System. Then channel scan is run normally. N The PIN input screen appears. Enter your 4 digit PIN number. . Satellite Selection: You can choose the satellites for this TV. . LNB Power: Enables or disables the power supply for the LNB. . LNB Settings: Configures the outdoor equipment. Satellite: Selects the satellite for receiving digital broadcasts. Transponder: Selects a transponder from the list or adds a new transponder. DiSEqC Mode: Selects DiSEqC mode for the selected LNB. Lower LNB Oscillators: Sets the LNB oscillators to a lower frequency. Upper LNB Oscillators: Sets the LNB oscillators to a higher frequency. Tone 22 kHz: Selects the Tone 22 kHz depending on the LNB type. For a universal LNB it should be Auto. Signal Quality: Display the current status of broadcasting signal. . SatCR/Unicable Settings: Configure single cable installation. N This function may not support depending on the region. SatCR/Unicable: Enables or disable single cable installation support. Slot Number: Select the SatCR user slot number for this receiver. Slot Frequency: Enter the appropriate frequency to receive the signal from SatCR. Detect Slot Frequency: Auto-detect the signal frequency for the selected slot number. Verify Slot Frequency: Verify that the frequency entered corresponds to the selected slot. . Positioner Settings: Configures the aerial positioner. Positioner: Enables or disables the positioned control. Positioner Type: Sets the positioned type between DiSEqC 1.2 and USALS (Universal Satellite Automatic Location System). – My Longitude: Sets the longitude for my location. – My Latitude: Sets the latit...
Other models in this manual:Televisions - UA32EH4030W (2.17 mb)
Televisions - UA32EH4500W (2.17 mb)
Televisions - UA32EH4530W (2.17 mb)
Televisions - UA32EH5300W (2.17 mb)