Votes - 4, Average rating: 4.8
(
)
)
|
manual abstract
WARNING/CAUTION WARNING Small parts can present choking hazard if accidentally swallowed. Keep small parts away from young children. Discard unneeded small parts and other objects, including packaging materials and plastic bags/sheets to prevent them from being played with by young children, creating the potential risk of suffocation. Set up This Plasma TV may fall and can cause personal injury or even death if not installed correctly. To prevent personal injury or death, follow these warnings: Install the Plasma TV in accordance with the manufacturer’s recommended pedestal or stand, corresponding hardware and installation instructions. This Plasma TV is for use only with the following optional accessories. Use with any other type of optional accessories may cause instability. The following accessories are manufactured by Panasonic Corporation. • Wall-hanging bracket (Angled) TY-WK4P1RW (TC-P42S2, TC-P46S2, TC-P50S2) TY-WK5P1RW (TC-P54S2) Be sure to ask a qualified technician to carry out theinstallation and set-up. Two or more people are required to install or remove the television. Some wall mounts (wall-hanging brackets) are notdesigned to be mounted to walls with steel studs or oldcinder block constructions. Ask your dealer or licensed contractor to properly secure the wall-hanging bracket. Do not route the TV’s power cord inside the wall. The power cord was not designed for in-wall mounting. Doing so can lead to fire hazard. Do not place the Plasma TV or its stand on a sloped orunstable surface. The Plasma TV may fall or tip over. Do not support the Plasma TV on a non-specified pedestal. Do not place the Plasma TV on furniture that can easilybe used as steps, such as a chest of drawers. Do not climb or allow children to climb on the Plasma TV Place or install the Plasma TV where it cannot be pushed, pulled over or knocked down. Route all cords and cables such that they cannot betripped over or pulled by curious children. Do not place any objects on top of the Plasma TV. If water spills onto the Plasma TV or foreign objects get inside it, a short-circuit may occur which could result in fire or electric shock. If any foreign objects get inside the Plasma TV, please consult an Authorized Service Center. In the unlikely event that you receive a shock from this product it is possible that your household outlet may be wired improperly. Have an electrician verify that the TV’s outlet is properly wired. If the symptom persists, have the TV serviced by a qualified authorized technician. AC Power Supply CordTo prevent fire or electric shock: The Plasma TV is designed to operate on a 120 V AC, 60 Hz service. Insert the power cord plug as far as itwill go into the wall socket. If the plug is not fully inserted, heat may generate, which could cause a fire. The included power cord is for use with this unit only. Do not use any power cord other than that providedwith this TV. Do not handle the power cord plug with wet hands. Do not do anything that might damage the power supply cord. When disconnecting the power supply cord, hold theplug, not the cord. Do not use the power supply cord if the plug or cord isdamaged. Replace the cord or contact your Authorized Service Center Do not use a 3-prong to 2-prong AC plug adaptors to connect your TV’s plug to the wall outlet. Doing so will defeat the TV plug’s safety feature, which can lead to a shock hazard. If the wall outlet does not accommodate a 3-prong plug, have a qualified electrician replace your outlet and check the associated wiring. Handling the power supply cord Insert the power plug fully into the socket outlet. (If thepower plug is loose, it could generate heat and cause fire.) Ensure that the power plug is easily accessible. Ensure the earth pin on the power plug is securely connected to prevent electrical shock. • An apparatus with CLASS I construction shall be connected to a power socket outlet with a protective earthing connection. Do not touch the power plug with a wet hand. (Thismay cause electrical shock.) Do not use any power cord other than that providedwith this TV. (This may cause fire or electrical shock.) Do not damage the power cord. (A damaged cord may cause fire or electrical shock.) • Do not move the TV with the cord plugged in the socket outlet. • Do not place a heavy object on the cord or place the cord near a high-temperature object. • Do not twist the cord, bend it excessively, or stretch it. • Do not pull on the cord. Hold onto the power plug body when disconnecting cord. • Do not use a damaged power plug or socket outlet. If a problem occurs (such as no picture or no sound), or if smoke or an abnormal odor is detected from the Plasma TV, unplug the power supply cord immediately. Continued use of the TV under these conditions might cause a fire or permanent damage to the TV. Have the TV evaluated by an Authorized Service Center. Servicing of the TV by unauthorized personnel is strongly discouraged due to its high voltage. If water or an obj...
Other models in this manual:Televisions - TCP42S2 (2.27 mb)
Televisions - TCP46S2 (2.27 mb)
Televisions - TCP50S2 (2.27 mb)