Votes - 2, Average rating: 5
(
)
)
|
manual abstract
You may purchase alkaline batteries from your local RadioShack store. 1. Slide off the battery compartment cover. 2. Insert the batteries into the compartment (three above and one below) as indicated by the polarity symbols ( + and –) marked inside. 3. Replace the cover. Notes: • The TV can operate for about 4 hours with alkaline batteries. When the sound level lowers or the picture becomes unstable, replace the batteries. • The TV’s internal batteries automatically disconnect when you connect an adapter. AC POWER You can power the TV using a regulated 6V AC adapter of at least 500 mA, and a size B Adaptaplug™ adapter (neither supplied). Both are available at your local RadioShack store. Set the adapter’s voltage switch to 6V. Insert the Adaptaplug into the adapter’s cord, aligning + with TIP. Plug the Adaptaplug’s barrel plug into the TV’s DC IN 6V jack. Then plug the other end of the AC adapter cord into a standard AC outlet. Note: The adapter might become warm after extended periods of use. USING VEHICLE BATTERY POWER You can power the TV from a vehicle’s 12V power source ( such as a cigarette-lighter socket) using a 6V, 500-mA DC adapter and a size B Adaptaplug™ adapter ( neither supplied). Use an optional DC adapter to power the TV from a vehicle’s cigarette-lighter socket if the vehicle has a 12V DC, negative ground electrical system. Set the adapter’s voltage switch to 6V. Insert the Adaptaplug into the adapter’s cord, aligning + with TIP. Plug the Adaptaplug’s barrel plug into the DC IN 6V jack. Unplug the vehicle’s cigarette lighter and plug of the DC adapter cord into the cigarette-lighter socket. Note: If the TV does not operate properly when you DC power, be sure the cigarette- lighter socket is clean and that the plug is properly connected 1. Extend the rod antenna and slide UHF/ VHF/ OFF to VHF or UHF. The TV starts scanning and stops at the next active channel in the selected band. 2. Press TUNING to tune to a different channel. The tuning line on the screen aligns with the selected channel number below the screen. 3. To adjust the volume, rotate VOLUME located on the right side of the TV. 4. To adjust the picture to the desired brightness, rotate BRIGHT located on the right side of the TV. The brightness also changes with the screen’s angle. BACKLIGHT In low temperatures, the TV screen takes a few seconds to light, or it might be slightly red in color. This is not a malfunction. Normal operation resumes after a few seconds. USING AN EARPHONE For private listening, you can connect an optional earphone with a 1/ 8-inch plug to the EAR jack. This automatically mutes the built-in speaker. Cautions: •Set VOLUME to the lowest setting before you begin listening. Then adjust the volume to a comfortable • Do not use an earphone when operating a vehicle or riding a bicycle. This can cause a traffic hazard and can be illegal in some areas. Power Using Your TV Volume - Turn the dial to adjust the volume level. Bright - Turn dial to adjust the brightness level. Tuning Y / . - Turn dial to adjust the picture to the desired television channel. Use the stand to lean the TV against flat surfaces. Flat LCD - makes the TV more compact and uses less power than a standard picture tube. EAR Jack - Lets you enjoy private listening with an optional earphone. DC IN 6V Jack UHF/ VHF/ OFF Built- in Rod Antenna EAR Jack If you are in an area with weak TV signals, or inside a metal or concrete building, you might need an external antenna to improve reception. Connect the antenna to the EXT. ANT. jack. If your antenna wire is 75-ohm coaxial cable, use an F-to- mini plug adapter to complete the connection. If you have 300- ohm wire, use a 300-to-75 ohm mini plug adapter. Both are available at your local RadioShack store. EXT. ANT. Jack Optional Accessories External Antenna Size B Adaptaplug Alkaline Batteries 6V AC to DC Adapter 6V Vehicle DC Adapter Earphones EXT. ANT. Jack - Lets you connect an external antenna for optimum reception in weak signal areas. 2.3” LCD TV 16-3009BATTERY POWER Your TV requires four AA batteries ( not supplied). You may purchase alkaline batteries from your local RadioShack store. 1. Slide off the battery compartment cover. 2. Insert the batteries into the compartment (three above and one below) as indicated by the polarity symbols ( + and –) marked inside. 3. Replace the cover. Notes: • The TV can operate for about 4 hours with alkaline batteries. When the sound level lowers or the picture becomes unstable, replace the batteries. • The TV’s internal batteries automatically disconnect when you connect an adapter. AC POWER You can power the TV using a regulated 6V AC adapter of at least 500 mA, and a size B Adaptaplug™ adapter (neither supplied). Both are available at your local RadioShack store. Set the adapter’s voltage switch to 6V. Insert the Adaptaplug into the adapter’s cord, aligning + with TIP. Plug the Adaptaplug’s barrel plug into the TV’s DC IN 6V jack. Then plug the other end of the ...