Votes - 2, Average rating: 4.5
(
)
)
|
manual abstract
Do not expose the TV set to rain or excessive moisture. Avoid using the set in very warm or damp places and never use it in a bathroom. When cleaning dust off the picture tube disconnect the power first. You can wipe lightly with a piece of dry, clean and soft cloth. Avoid exposing the set to direct sunlight and other sources of heat to prevent damage to the cabinet and components. 1 3 4 2 2 ! ! This TV set can operate on an AC power of 240V, 50HZ. You must not use a power supply of any other type. 5 High voltage exists in this TV set. Do not remove the cover Do not cover the ventilating hole in the cabinet Keep a space of more than 5cm from the walls to the TV set to ensure adequate ventilation. 6 If the power cord or the plug is damaged contact a qualified service department for service. 7 8 When the TV set is to be left unattended for a long period of time, turn off the power supply and remove the plug from the wall outlet. 3 Introduction Identification of Controls Front/Back view Front 1. :Earphone Jack AV input terminals (VIDEO, AUDIO L/MONO, R) 2. MENU button: To enter into menu operation. 3. AV/TV button: Video input select. 4. VOL- button: volume down adjust; menu item adjust. 5. VOL+ button: volume up adjust; menu item adjust. 6. CH- button: channel down select; menu item select. 7. CH+ button: channel up select; menu item select. 4 Back 1. Antenna input 2. AV input (VIDEO, AUDIO L/MONO, R) 3. S-VIDEO input Back 1. Antenna input 2. AV input (VIDEO, AUDIO L/MONO, R) 3. S-VIDEO input 5 Introduction Identification of Controls (continued) Remote Controller Notes:! In most cases, the function of buttons are equal to the CH+/- buttons, and the function of buttons are / equal to the VOL+/- buttons; but in TELETEXT operation, the , , , buttons only serve as teletext control keys. 6 Effective range of the Remote Installing batteries 1 Open the battery cover. Install two "AAA" batteries matching the +/-polarities of the battery to the +/marks inside the battery compartment. 2 ! Replace the battery cover. Notes: ! 3 Notes: When there is an obstacle between the TV and the transmitter, the transmitter may not operate. When direct sunlight, and incandescent lamp, The battery life should be about one year under normal fluorescent lamp or any other strong light shines on use. Do not try to recharge batteries not intended to be the REMOTE SENSOR of the TV the remote operation recharged. may be unstable. Use only the size and type of batteries specified. Do not mix different types of batteries together or old batteries with fresh ones. When the remote control will not be used for a long period of time or when the batteries are worn out, remove the batteries. Do not throw the batteries into a fire. Dispose of used batteries in the specified manner. Do not drop, dampen or disassemble the remote control. 7 Installation INSTALL the unit in a room where direct light will not fall upon the screen. Total darkness or a reflection on the picture screen may cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing. Antenna Installation/Connect to video and audio equipment Antenna installation Optimum reception of colour requires a good signal and will generally mean that an outdoor aerial must be used. The exact type and position of the aerial will depend upon your particular area. ! Notes: It is recommended that the 75-ohm coaxial cable be used to eliminate interference and noise which may occur due to radio wave conditions. The aerial cable should not be bundled with the power cord and the like. 8 Connect to video and audio equipment This TV set provides 2 groups of AV input terminals for your convenient connection to VTR, DVD or video camera to enjoy the high quality picture. Please refer to the owner's manual of the equipment to be connected as well. Important notes on the AV input terminals Please do not connect and use the front and rear input terminals at the same time. You can also use the AV terminals on the TV set rear as follows. Please do not connect and use the S-VIDEO and VIDEO terminals at the same time. Please note that the rear audio input terminals are stereo while the front are mono. ! Notes: 9 Operations Turning on/off Turning on/off Turning on 1 Press the Power Switch on the TV set. If no picture appears, then the TV set is in STANDBY mode. Now please follow step 2. 2 2 In STANDBY mode, press the button on the 3 3 remote controller and the TV set is turned on. In STANDBY mode, you can also press the AV/TV button on the set to turn on. ! Notes: If there is no input signal, then a blueback appears. After 15 minutes, the set auto goes to STANDBY. 1 1 Turning off Press the Power Switch on the TV set if you want to cut off the power completely. 2 2 If you want to turn off the TV set temporarily, press the button on the remote controller. 10 Operations Select Input Signal Select input signal Select input signal 1 Press AV/TV button on the TV set or AV button on the remote control. When ...