Junction Box URC-5F R-5, S-5, T-5 1 2 3 4a4 Title: B. Junction Box Model: URC-5F Index No. Description Material or Model Number Part Number Required Number R-5 to T-5 1 Junction Box (A) GS 3A0170-01 1 2 Bushing OCB-1000 428394-05 1 3 Bushing SR-30-1 420472-03 1 4 Capacitor 10.0MFD, 250V 443192-01 1 4a T2 Screw 4.10, SS 7P32-0410 1 7 C. Accessories & Packaging URC-5F R-5, S-5, T-5 Title: C. Accessories & Packaging Model: URC-5F Index No. Description Material or Model Number Part Number Required N

Failure to do so could result in bodily injuries and/or Safety InstructionsRead all instructions before using this appliance -emely important that you read and adhere to the following property damage due to fire. •Use this appliance only for its intended purpose as described in this Owner’s Manual. This dryer must be: -Properly installed and located in accordance with the Installation Instructions before it is used. -Properly grounded to conform with Local Codes. Follow details in Installation I

Pushing the button toggles the setting as follows: Cotton..Synthetic..Cotton 5. The AIRING button When pressed, not only is the airing feature enabled but the 50 minute time light is illuminated. This is because the feature runs the dryer in cool mode (no heat) for 50 minutes. The running time can be altered by pressing the time button. Each press changes the time setting as follows: 50 minutes..40 minutes ..30 minutes..20 minutes ..50 minutes 6. The SIGNALbutton Set to OFF at the factory. When

In New Zealand, please call 09 912 0747 ‘Sunbeam’, is a registered trademark of Sunbeam Corporation. Made in China. Due to minor changes in design or otherwise, the product may differ from the one shown in this leaflet. Backed by Sunbeam‘s 2 Year Replacement Guarantee and National Service Network. © Copyright. SUNBEAM CORPORATION LIMITED 2003. (INCORPORATED IN N.S.W.) A.C.N. 000 006 771 Sunbeam Corporation is a division of GUD Holdings Ltd. For more information or advice on this or any other Sun

CalClean should be applied liberally to entering air and leaving air surfaces of the finned area in accordance with the label directions. CAUTION: Under no circumstances should this unit be cleaned with an acid-based cleaner. Figure 10. Figure 9. *If receiver is located in a warm ambient, a check valve in this location may be required to prevent receiver gas from migrating into the condenser during the off cycle. Table 6. FHP Charge Factor; T.D. 25 and 30 .F Minimum Ambient Additional Charge Fac

Drucken Sie die Taste „Kreukvrij/Anti-froissage“, um diese Funktion zu aktivieren. Die Anzeigeleuchte uber dem Block leuchtet auf, wenn der Knitterschutz aktiviert wird. Getrocknete Wasche knittert nicht, weil die Trommel nach dem Trocknen in regelma.igen Abstanden rotiert wird. Selbst wenn „Ende“ angezeigt wird, dreht sich die Trommel regelma.ig. Start/Pause – Auswahltaste Drucken Sie diese Taste, um ein Trockenprogramm zu starten. Wenn Sie die Taste im laufenden Betrieb des Trockners drucken,

Verbinden Sie das Netzkabel nur mit einer Wandsteckdose mit 220/240 V~ bei 50 Hz und verwenden Sie die Steckdose nur fur dieses Gerat. Verwenden Sie au.erdem kein Verlangerungskabel. - Wenn Sie eine Wandsteckdose gemeinsam mit anderen Geraten benutzen (mit Hilfe einer Steckerleiste oder eines Mehrfachsteckers) konnen Stromschlage oder Brande verursacht werden. - Stellen Sie sicher, dass Netzspannung, Frequenz und Stromstarke den Angaben in den technischen Daten des Gerats entsprechen. Andernfall