Votes - 3, Average rating: 3.7 ( )

Manafacture: Sears File size: 171.37 kb File name: Language of manual:

This helps prevent overdrying. Lint Alert Clean the lint screen before each load. If you do not, your dryer may not operate properly. If enough lint accumulates to clog the lint screen, a continuous whistle tone will sound. Turnoff the dryer, remove the lint screen, clean and replace it. When the dryer is restarted the sound will stop. Cooldown Approximately ten minutes before the end of the AUTOMATIC and TIMED DRY Cycles, clothes are tumbled without heat to help reduce wrinkles and make clothes more comfortable to handle. TOUCH-UP Cycle Use this cycle to "smooth" synthetic and permanent press clothes that are clean but wrinkled from being crowded in a closet or suitcase. This setting provides about 15 minutes of heated tumbling followed by a 10-minute (approx.) cooldown. • Put just a few garments into the dryer. • Set the Cycle Selector Control to TOUCH-UP. • Set the Heat Temp Control to the type of fabric in the load. • Push the StartControl. • Remove clothes immediately when tumbling stops. TIMED DRY Cycle Use this cycle to get up to 70 minutes of heated drying time. The heating cycle is followed by a 10-minute (approx.) cooldown. • Set the Cycle Selector Control to the amount of time you want in the TIMED DRY Cycle. • Set the Heat Temp Control to the type of fabric in the load. • Push the Start Control. Wrinkle Guard I Wrinkle Guard I helps keep your permanent press items wrinkle free when you cannot unload the dryer promptly at the end of the Automatic Cycle. If you do not open the door at the end of the Automatic Cycle, Wrinkle Guard I will tumble the clothes without heat for 30 minutes unless you open the dryer door sooner. During Wrinkle Guard I the End-of-Cycle Signal will sound'after every 5 minutes unless the control is off. FEATURES E1 Lint Screen Keep the lint screen clean. A lint-clogged screen will slow down the flow of air. This makes drying time longer and wastes energy. Clean the lint screen before each load as follows: 1. With dryer off, remove the screen by pulling straight up. 2. Roll the dry lint off the screen. Do not wet the screen or lint; wet lint is hard to remove. 3. Replace the cleaned lint screen. Fire Hazard. Do not use your dryer while the lint screen is removed. It could cause overheating and possible damage to fabrics and dryer parts or create a fire hazard. Lint screen must be pushed firmly into place. III III NOTE: A whistle tone will remind you when the lint screen needs cleaning. NOTE: If lint screen gets clogged by detergent or fabric softener build-up, remove and clean it with a nylon brush, hot water and liquid detergent. Dry and replace screen. i_ Safety Door Switch For safety, the switch shuts off dryei when door is opened. Dryer will not start until door is closed and START is pushed. Be sure the Cycle Selector Control is on a dry setting. Ik_ Model No. Plate Shows model and serial numbers. Have these ready if you ever call for service. l_ Performance Guide Label Located inside the dryer door. Gives information on what to do if dryer does not perform normally. •El Easy Loader Door Drop down door is located to reduce stooping. It can also serve as a shelf for folding clothes. The large opening makes it easy to load and unload and to see inside dryer. Clothes in dryer are easy to reach. NOTE: If dryer drum is stained, clean it with a damp cloth and mild detergent. For more detailed drying times, roles for safe operation, fabric care, maintenance and installation information, refer to the LAUNDRY GUIDE and INSTALLATION INSTRUCTIONS you received with yourdryer. ii Part No. 3392334 Printed in U.S.A. ...

Download now

Please, enter two numbers from picture: