Votes - 4, Average rating: 3.8 ( )

Manafacture: Combi File size: 237.54 kb File name: Language of manual:

Removing the Seat Cushion 1. Unbuckle the 5-point harness and pull the straps out from seat cushion. 2. Grasp the seat cushion and carefully remove. Attaching the Seat Cushion 1. Pass the 5-point harness straps through the appropriate openings in the seat cushion. 2. Shape the cushion to the seat frame and velcro into position. 3. Loop the right and left side bands around the hooks located behind the seat of the main unit. Attaching/Removing the Tray CAUTION Before using, check to see that the tray is locked into the position you set. Pay attention so that the child’s fingers are not in the guide on the side of the main unit to avoid injury. Attaching the Tray 1. Insert the tray along the guides on the sides of the main unit. 2. Pull the lever located under the front of the tray and slide the tray back until a comfortable position is found for your child. Position the tray so that the sides are locked into matching positions. Removing the tray Locate the tray release lever and pull off. - 3 - Using the Reclining Backrest CAUTION Always adjust the harness when changing the reclining angle. Always keep the reclining lock lever in the lock position. Be careful that there are no obstacles in front of it before using since the footrest will move during the recline. • Use the high chair with the backrest in the full recline position to carry 2-3 month old babies without a strong neck. • The backrest can be adjusted to 5 positions. • The footrest angle changes along with the recline. 1. To recline the backrest, pull and hold the reclining lock lever located on the back of the seat. 2. After the recline position is determined, always lock the reclining lock lever by releasing it to its original position. To return the backrest to the upright position, pull and hold the reclining lock lever and push the seat forward. The seat will lock into place again by releasing the reclining lock lever. Full upright 1 2 3 4 5 Full recline Reclining Lock Lever Using and Adjusting the 5-Point Harness WARNING Avoid serious injury from falling or sliding out. Always use harness for security. 1. Place the crotch belt between the child's legs. 2. Insert both waist belt buckles into the middle plastic piece. 3. Attach each shoulder strap hooks to the top of the waist belt clips. 4. To adjust the harness or waist belt, loosen the slack on both sides of each buckle. CAUTION Even when the harness is fastened, be careful not to let the child slip out or stand. CAUTION Always keep the wheels locked other than when moving the high chair. Failure to do so may cause the high chair to move unexpectedly. Wheels must be locked when using the glide feature. Attaching & Using the Wheels Front Swivel Wheels Insert the swivel wheels, with the circular shaft, into the circular hole in the base of the front legs. Rear Stationary Wheels Insert the rear wheels, with the square shaft, into the square hole in the base of the rear legs. To lock wheels, lower the brake lever. (Down position.) To unlock wheels, lift the brake lever. (Up position.) - 4 - Brake Lever Using the Gliding Feature WARNING Never push the high chair like a swing. It may fall over and cause your child to fall out. CAUTION The gliding feature can be used in any recline position up to a maximum of 22 lbs. Always watch your child when using the glide. Immediately stop if you sense something is wrong. Check to make sure obstacles are not within its gliding path. 1. Always lock the front wheels. Keep wheels locked. 2. Adjust the reclining position to the appropriate position for your child’s age and strength. 3. Slide the left and right glide lock levers into glide position. Use a smooth and gentle motion never a hard push. 4. To lock the glide feature slide the glide lock levers into the lock position. Deluxe Easy Glider 9850 Series Additional Instructions Attaching the Canopy CAUTION Failure to fully secure the canopy holders can cause the holders to bend. When storing the high chair by laying it down, be sure the canopy is off the ground to prevent it from bending. Attaching the Canopy 1. Confirm the canopy is facing in the proper direction. 2. To attach the canopy place the pins in the clamps of the canopy holders into the holes on the sides of the backrest. Note: Clamp must be turned to be positioned behind the canopy holder in order to insert into the frame. Using the Canopy Open the canopy by pulling on the visor with one hand until fully opened. Removing the Canopy Grasp the canopy holders on each side, one at a time, and pull out from the frame. - 5 - Installing the Speakers CAUTION Be sure to test the volume on your player. Set it at a comfortable level so that it does not startle your child when turning it on. Loud volume can hurt your child’s ears. If you notice that the sound has become weak or distorted or if tracks do not change, this is an indication that your batteries are low. Replace the batteries and set the volume at a comfortable level. 1. The canopy comes with a small...

Download now

Please, enter two numbers from picture: