Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
manual abstract
Englis
useful tips for your drum washing machine
Cleaning the debris filter
h
✔ When water does not drain well or ‘5E’ blinks on the display, clean the debris filter. The product appearance
may differ from your washing machine. (However, the cleaning descriptions are the same.)
Germa
1. Open the filter
4. Unscrew the
✔ The descriptions and images in this document may differ from your actual
purchased product. For more information, refer to the user manual.
cover using a coin
emergency drain
n
or a key.
cap by turning it
counter clockwise.
Fr
INSTALLING YOUR WASHING MACHINE
enc
h
• Installing your washing machine in the location which is slippery
2. Unscrew the
5. Clean the debris
or uneven, will result in vibrations and noise.
emergency drain
filter and the inside
• If there is too much noise or vibration, check whether the four
cap and pull out the
of the drain hose.
Spanis
levelling adjustment legs are evenly and firmly on the floor.
emergency drain
• If the washing machine is not level, lift the washing machine
tube to drain off the
Inside
Debris
h
slightly and adjust the lowest of the four levelling adjustment legs.
remaining water.
filter
✔ Before using your washing machine, you must remove the
Make sure that the leveling feet
shipping bolts from the back of the unit.
legs are level with the floor.
3. Hold the cap on
6. Replace the
I
talia
For more information on removing the safety devices, refer to the user manual.
the end of the
debris filter, the
emergency drain
emergency drain
n
LEVELLING YOUR WASHING MACHINE WITH THE LEVELLING FEET
tube and allow all
cap and tube and
the water to flow
then close the filter
Portugues
✔ Refer to the descriptions appropriate to your washing machine.
into a bowl.
cover.
Locking nut
✔ If you open the debris filter when water remains inside the tub, water may flow out.
e
Adjustable nut
✔ If the debris filter is assembled incorrectly or not installed, it may cause a water leakage or operating error.
Spanner
Russia
1. Level your washer by turning the
2. When your washing machine is
Therefore make sure to assemble it correctly.
(-) Driver
adjustable nut in and out, as shown
level, tighten the locking nut using
in the figure.
the (-) driver.
MAKE SURE YOU KNOW...
n
Adding the
• Adding laundry
Nut
laundry
➲ Press the Add laundry(Stop&Add) button and add the laundry when the Add
Adjustable feet
laundry lamp turns on.
Spanner
1. Unfasten the locking
2. Level your washing
3. Fasten the locking
• If you add the laundry during a spin cycle, it starts again with the initial set time
nut by turning it to the
machine by turning
nut by turning it to the
regardless of the remaining time.
left using a spanner.
the adjustable feet in
right using a spanner.
and out as necessary
by hand.
Washing
• Wash bedding using only the Bedding course.
bedding
Wash
➲ You can wash acrylic, mixed spinning and woolen bedding.
individually.
CLEANING THE FILTER
➲ When washing general clothes, the washing machine may
not operate in the optimal status.
Cleaning the water supply filter
• Wash only one bedding item at a time regardless of size.
➲ Insert bedding rolled up into a ball.
✔ If the filter net is not installed, it may cause a water leakage and operating error. Make sure to install it.
The center of gravity is distributed evenly causing less
vibrations and noise.
✔ Do not wash electric blankets or carpets.
✔ When spinning blankets, cotton bedding, and woolen bedding,
too much noise and vibrations may occur and the wash cannot
be completed as spinning is not performed.
1. Pull and remove the filter net.
2. Clean the filter.
3. Insert the filter net and fasten
its connector firmly.
...