Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
manual abstract
Risk of explosion! – Items of laundry pretreated with cleaning agents containing solvents, e.g. stain remover/cleaning solvent may lead to an explosion after being loaded into the washing machine. Rinse items of laundry thoroughly by hand beforehand. Risk of injury! – The washing machine door may become very hot. – Be careful when draining hot detergent solution. – Do not climb onto the washing machine. – Do not lean on the open washing machine door. – Do not reach into the drum if it is still rotating. – Be careful when opening the detergent drawer while the machine is in operation. Consumption values depending on model Programme Load Electricity*** Water*** Programme duration*** algodon/algodao 20 °C 8 kg 0.37 kWh 68 l 2 . h algodon/algodao 30 °C 8 kg 0.40 kWh 68 l 2 . h algodon/algodao 40 °C* 8 kg 1.05 kWh 68 l 2 .. h algodon/algodao..60 °C 8 kg 1.15 kWh 68 l 2 .. h algodon/algodao..90 °C 8 kg 2.30 kWh 80 l 2 .. h sinteticos 40 °C* 3.5 kg 0.64 kWh 55 l 1 .. h rapido mix 40 °C 3.5 kg 0.54 kWh 47 l 1 h delicados 30 °C 2 kg 0.19 kWh 34 l .. h lana/la 30 °C 2 kg 0.17 kWh 39 l .. h * Programme setting for testing in accordance with valid standard EN60456. Note on comparative tests: For testing the test programmes, wash the specified load using the maximum spin speed. Programme Additional function Load Annual energy consumption Annual water consumption algodon/algodao 40/60 °C + eco ..** 8/4 kg 179 kWh 8700 l ** Programme setting for testing and energy labelling in accordance with EU directive 2010/30/EU with cold water (15 .C). *** The values deviate from the indicated values depending on water pressure, hardness, and inlet temperature, ambient temperature, type, amount and soiling of the laundry, detergent used, fluctuations in the power supply and selected additional functions. 9 Care and cleaning Before the first wash Do not put laundry in the machine! Turn on the tap. Put into compartment II: – approx. 2 litres of water – detergent (measure according to the manufacturer's instructions for lightly soiled laundry and water hardness) Turn the programme selector to sinteticos (Easy-Care) 60 °C and press inicio (Start/Reload). At the end of the programme, turn the programme selector to o (stop). Machine housing, control panel – Remove detergent and cleaning agent residue. – Do not use any abrasive cloths, scourers or cleaning agents (stainless steel cleaners). – Do not wash the machine with a jet of water! Cleaning the detergent drawer ... ... if it contains detergent or fabric softener residues. 1. Pull out, press insert down and remove drawer completely. 2. To remove the insert: press upwards from below with your finger. 3. For models with insert for liquid detergent:Slide the insert upwards and remove it from the back. 4. Clean the detergent dispenser tray and inserts with water and a brush and dry them. 5. Attach the insert and engage (connect the cylinder to the guide pin). 6. Push in the detergent drawer. Leave the detergent drawer open so that any residual water can evaporate. Drum Leave the washing machine door open so that the drum can dry out. For rust stains, use chlorine-free cleaning agent, not steel wool. Descaling Ensure there is no laundry in the machine! This will not be necessary if the correct dosage of detergent is used. If it is, descale the appliance according to the manufacturer's instructions. Descaling products can be acquired on the website or from customer services ..Installation instructions. Emergency release (e.g. in the event of a power cut) The programme continues to run when the power has been restored. However, if the laundry has to be removed, the washing machine door can be opened as follows: Risk of scalding! The detergent solution and laundry may be hot. Let it cool. Do not reach into the drum if it is still rotating. Do not open the washing machine door if water can be seen through the glass. 1. Turn the programme selector to o (stop) and disconnect the mains plug. 2. Drain the detergent solution ....page 10. 3. Pull the emergency release downwards with a tool and release. The washing machine door can then be opened. Information on the display panel depending on model .. flashes Close the washing machine door properly; laundry may be caught. ..: ...., ..: .... Turn on the (cold water) tap fully, supply hose kinked or trapped; Clean the filter ....page 10, water pressure too low. ..: .... – Detergent solution pump blocked; Clean the detergent solution pump ....page 10. – Drainage hose / waste pipe blocked; Clean the drainage hose at the siphon ....page 10. – Heavy foam build-up ....page 11, status indicator .. flashes. ..: .... Water in the base tub, appliance leaking. Call customer services! ..: .... – Open the (hot water) tap fully. – Inlet hose kinked/trapped. – Water pressure too low. Clean the filter ....page 10. – Hot water hose not connected; appliance will operate using cold water only. Ignore information, only for first wash cycle. .. Childproof lock activated: to...
Other models in this manual:Washers - 3TS883A/11 (1.68 mb)
Washers - 3TS883A/12 (1.68 mb)
Washers - 3TS883XP/01 (1.68 mb)
Washers - 3TS883XP/11 (1.68 mb)