Votes - 0, Average rating: 0
(
)
)
|
manual abstract
/ lana/la (Wool) 30 °C 2 kg 0,20 kWh 32 l 00:53 h * Programme setting for testing in accordance with valid standard EN60456. Note on comparative tests: For testing the test programmes, wash the specified load using the maximum spin speed (depending on model). Programme Load Annual energy consumption Annual water consumption algodon/algodao eco (Cottons eco) 40/60 °C** 7/3,5 kg 219 kWh 10900 l ** Programme setting for testing and energy labelling in accordance with EU directive 2010/30/EU with cold water (15 .C). *** The values deviate from the indicated values depending on water pressure, hardness, and inlet temperature, ambient temperature, type, amount and soiling of the laundry, detergent used, fluctuations in the power supply and selected additional functions. 9 Care Before washing for the first time Do not load any laundry into the machine. Turn on the tap. Add the following to compartment II: – approx. 1 litre water – detergent (dosage according to the manufacturer's instructions for light soiling and the appropriate degree of water hardness) Set the programme selector to sinteticos (Easy-Care) 60 °C and select .. inicio (Start). At the end of the programme, turn the programme selector to stop (Off). Machine housing, control panel – Wipe with a soft, damp cloth. – Do not use any abrasive cloths, scourers or cleaning agents (stainless steel cleaners). – Remove detergent and cleaning agent residue immediately. – Do not clean with a jet of water. Cleaning the detergent drawer and housing... ...if it contains detergent or fabric softener residues. 1. Pull the drawer out, press down the insert and fully remove the drawer from the housing. 2. To remove the insert: press the insert upwards from below with your finger. 3. Clean the detergent dispenser tray and insert with water and a brush and dry it. Also remove any detergent or fabric softener residues in the housing. 4. Attach the insert and engage (connect the cylinder to the guide pin). 5. Push in the detergent drawer. Leave the detergent drawer open so that any residual water can evaporate. Washing drum and rubber seal Wipe the inside of the rubber seal dry with a cloth. Leave the washing machine door open so that the drum can dry out. Rust stains - use chlorine-free cleaning agent, not steel wool. Descaling Ensure there is no laundry in the machine Descale the appliance according to the descaler manufacturer's instructions. This should not be necessary if the correct dosage of detergent is used. Information to indicator lights Indicator lights for status displays and/or buttons flash: Indicator lights ....(Rinse) and ....(Wash) flash Close the washing machine door properly; laundry may be caught. Indicator lights ....(Spin) and ....(Wash) flash Open the tap completely, supply hose kinked or trapped; Clean the filter .. page 10, Water pressure too low. Indicator lights ....(Spin) and ....(Rinse) flash Detergent solution pump blocked; Clean the detergent solution pump .. page 10. Drainage hose/waste pipe blocked; Clean the drainage hose at the siphon .. page 10. Indicator light ....(Rinse) flashes Motor fault. Call the after-sales service. All indicator lights flash Turn off the tap and call the after-sales service. – Risk of electric shock. Disconnect the mains plug. – Risk of explosion. No solvents. 10 Maintenance Detergent solution pump Turn the programme selector to stop (Off) and disconnect the main...
Other models in this manual:Washers - 3TS873/08 (1.51 mb)
Washers - 3TS873/09 (1.51 mb)
Washers - 3TS873/10 (1.51 mb)
Washers - 3TS873E/03 (1.51 mb)