Votes - 0, Average rating: 0 ( )

Manafacture: Bosch File size: 2.71 mb File name: Language of manual:

Other manuals for this model:

Washers - WTW86360EE/10 (2.72 mb)

. The dryer is very heavy. Do not attempt to lift it on your own. . Be careful to avoid sharp edges. . Do not set up in a room that is susceptible to frost. Freezing water may cause damage. . If in doubt, have the appliance connected by a specialist. . Do not lift the dryer by protruding parts (e.g. the door) -risk of breakage. 1. Setting up the dryer . The appliance plug must always be accessible. . Ensure that the appliance is installed on a clean, level and firm surface. . Do not obstruct the air inlet on the front of the dryer. . Keep the area around the dryer clean. . Make the dryer level using the threaded feet and a spirit level. . Do not remove the threaded feet under any circumstances. Take all accessory parts out of the drum. The drum must be empty. Fr2. Mains connection see Safety instructions a page 13. . Connect to an AC earthed socket. If in doubt have the socket checked by a specialist. . The mains voltage and the voltage shown on the rating plate (a page 10) must be the same. . The connected load and necessary fuse protection are specified on the rating plate. ost protection Make sure that the air inlet remains unobstructed Clean and level Do not set up the dryer behind a door or sliding door, as this may obstruct the dryer door or prevent it from opening. This will prevent a potentially fatal danger to children from locking themselves in. Do not operate the dryer if there is a danger of frost. Preparation 1. Empty the condensation container a page 4. 2. Select any programme using the programme selector. 3. Press the Inicio/Stop (Start/Stop) button a condensed water is pumped into the container 4. Wait 5 minutes and then empty the condensation container again. 5. Turn the programme selector to Stop. Transport 8 . Prepare the dryer a see Frost protection. . Transport the dryer in a vertical upright position. . Following transportation, do not use the dryer for two hours. The dryer contains residual water; this can flow out if the dryer is tilted. 9Care and cleaning Heat exchanger The dryer's heat exchanger is cleaned automatically during drying. Clnappears in the display panel. Do not pull out the condensation container during the cleaning process. Dryer housing, control panel, air intake Wipe with a soft, damp cloth. Do not use harsh cleaning agents or solvents. Remove detergent and cleaning agent residue immediately. Some water may collect between the window and the seal during drying. This does not affect the proper operation of your dryer in any way. Filter in the condensation container The filter is cleaned automatically when the condensation container is emptied. However, the filter should still be cleaned regularly under running water ..This prevents stubborn deposits/dirt from building up. 1.Pull out the condensation container. 2.Pull the filter out of its snap-in lock. 3.Clean the filter under running water or in the dishwasher. 4.Refit the filter. 5.Insert the condensation container so that it locks into place. Only operate the dryer with the filter inserted. Moisture sensor The dryer is equipped with stainless steel moisture sensors. Moisture sensors measure how damp the laundry is. A thin layer of limescale may build up on the moisture sensors after prolonged use. 1.Open the door. 2.Clean the moisture sensors using a damp sponge with a rough surface. Do not use steel wool or abrasive materials. Appliance must be switched off. Technical data . Dimensions (DxWxH) 60 x 60 x 85 cm (height adjustable) Weight approximately 51 kg Max. capacity 7 kg Condensation container 4.0 l Connection voltage 220-240 V Connected load max. 1000 W Fuse protection 10 A Ambient temperature 5 35°C Product number Production number under the door The rating plate can be found on the back of the dryer. . Drum interior light (depending on model) (bulb E14, 25 W) The drum lights up after the door is opened or closed, and after the programme starts, and switches off automatically. Changing the bulb a page 12. Consumption rates Fabrics/programmes Residual moisture in the fabrics after spinning Drying time** Energy consumption** Cottons / Coloureds 7 kg Cupboard Dry* 1400 rpm (50%) 133 min 1.88 kWh 1000 rpm (60%) 155 min 2.20 kWh 800 rpm (70%) 176 min 2.54 kWh Iron Dry* 1400 rpm (50%) 96 min 1.31 kWh 1000 rpm (60%) 118 min 1.64 kWh 800 rpm (70%) 138 min 1.97 kWh Easy-Care 3.5 kg Cupboard Dry* 800 rpm (40%) 54 min 0.57 kWh 600 rpm (50%) 68 min 0.72 kWh * Pro** The to bgramme setting for testing in accordance with applicable standard EN61121. values may differ from those specified, depending on the type of fabric, composition of laundry e dried, residual moisture in the fabric and the amount of laundry being loaded. Fabrics/programmes Drying time Annual energy consumption Cottons / Coloureds 7 kg / 3.5 kg* Cupboard Dry*** 124 min / per cycle 279 kWh / per year *** Prosetting for testing and energy labelling in accordance with Directive 2010/30/EU. gramme Optional accessories (from after-sales service using order num...

Download now

Please, enter two numbers from picture: