Votes - 0, Average rating: 0
(
)
)
|
manual abstract
The temperature remains constant during the washing process. More intensive rinsing with increased water level. For hard-wearing and easy-care fabrics made from cotton or linen. Night Wash S Particularly quiet wash programme with a reduced final spin. Sleep mode. Once the programme has finished, the display goes out, but can be reactivated by pressing any button. Intensive Dry 5 Intensive drying for a (robust fabrics), at 90°C. Gentle Dry ‰ Gentle drying for ` (easy-care fabrics), 60°C. Fluff Clean l This programme is designed to clean the drying cycle of any fluff deposits. After 10 drying cycles, the washer-dryer uses the symbol l (Fluff Clean) in the display panel to show that this programme should be run. The electronic cycle counter is then automatically reset. The l (Fluff Clean) symbol goes out after the programme starts. To run the Fluff Clean l, proceed as follows: • Make sure that the drum is completely empty and close the door. • Turn the programme selector to Fluff Clean l. • Press the A (Start/Pause) button. The Fluff Clean l programme can also be run at any time without prompting by the appliance. ' + B Rinse + Spin: An additional rinse cycle with a final spin. If the laundry is to be removed dripping wet, set the Schleuderdrehzahl (Spin speed) to $ (Rinse hold) before Programme start –> page 13. [ + B Drain + Spin: Drain the rinsing water following a programme with $ (Rinse hold) –> page 13. • Turn the programme selector to [ + B Drain + Spin. • Set the spin speed to $ (Rinse hold). • Press the A (Start/Pause) button. or Drain and spin at the desired spin speed: • Turn the programme selector to [ + B Drain + Spin. • Press the B (Spin) button repeatedly until the desired spin speed is set. • Press the A (Start/Pause) button. Washing and drying options Temperature °C button Spin speed button B Rinse hold Unbalanced load detection system option button set button i The temperature can be adjusted individually for each programme. To adjust it, press the °C (Temperature) button repeatedly until the required temperature is displayed. The spin speed can be individually adjusted for each programme. To set the spin speed, press the B (Spin) button repeatedly until the required spin speed is displayed. $ (Rinse hold) deactivates the spin function. The laundry remains in the rinsing water. The automatic unbalanced load detection system ensures that the laundry is evenly distributed using several initial spins. If the laundry is extremely unevenly distributed, the speed of the final spin is reduced or the spin cycle is not performed for safety reasons. The set programmes can be individually adjusted. To choose the required option: • Press the option button repeatedly until the required option is selected (indicator lamp flashes). • Press the set button to switch the option on/off (indicator lamp lights up/does not light up). If you press and hold the option ~ button, all the options scroll through. Options (symbols on the display panel) T Pre-wash Prewash at 35 °C. Suitable for heavily soiled laundry. X Intensive Prolonged washing time. Suitable for particularly heavily soiled laundry with dried-on stains. Cannot be combined with R Flexi Time Q Easy-iron Special spin sequence with subsequent fluffing. Gentle final spin at reduced speed. Slightly increased residual moisture in the laundry. Reduces creasing and laundry is easier to iron. Z Water Plus Increased water level and additional rinse cycle. For regions with very soft water or for further improving the rinsing result. Any detergent residues are removed. R Flexi Time Sets the washing time. normal-medium-short. C Signal Activates or deactivates the audible signal. 0 Finished in button You can postpone Programme start before it begins. Using the Remaining time, you can determine when the selected programme is to end. The remaining time can be set in one-hour increments, up to a maximum of 24 hours. Press the 0 (Finished in) button repeatedly until the required number of hours is displayed. Then press the A (Start/Pause) button, the programme will start after a delay according to the set (Remaining time). The required time to the end of the programme is shown on the display panel. The drying programmes –> page 12 can be individually adapted by Drying button 5 selecting the drying options. – Press the 5 (Drying) button repeatedly until the required drying option is shown on the display panel. – To deactivate, press the 5 (Drying) button repeatedly until is shown on the display. Drying options (symbols on the display panel) 0 Time-controlled The drying time can be set to between 2:40 and 0:00 by repeatedly pressing the drying 5 (Drying) button. P Iron-damp The residual moisture in the washing is increased. Enables easier ironing. e Cupboard-dry The laundry is dry and ready to put away. e: Extra-dry The laundry is dried intensively. Suitable for laundry that is hard to dry. Press the A (Start/Pause) button to start the selected programme. Start/Pause butto...
Other models in this manual:Washers - WKD28540GB/03 (814.52 kb)