Votes - 0, Average rating: 0 ( )

Manafacture: Bosch File size: 1.98 mb File name: Language of manual:

Connection fittings for condensation outlet The condensation is conveyed directly via a hose. Installation underneath the worktop Instead of the appliance covering plate, you must have a metal cover fitted by a specialist. CZ11390WZ20160WZ2029010Installation – Scope of delivery: dryer, installation and instruction manual, jug, basket for woollens (depending on the model). – Check dryer for transport damage. – The dryer is heavy. Do not attempt to lift it on your own. – Be careful to avoid sharp edges. – Do not install in a room where there is a risk of freezing. Freezing water may cause damage. – If in doubt, have the appliance connected by a specialist. – Do not lift the dryer by protruding parts (e.g. the door) -risk of breakage. Setting up the dryer – The appliance plug must always be accessible. – Ensure that the appliance is installed on a clean, level and firm surface. – Keep the cooling grille on the front of the dryer clear. – Keep the area around the dryer clean. – Level the dryer using the threaded feet. Use a spirit level. – Do not remove the threaded feet under any circumstances. Mains connection see safety information ..page 13. – Connect to an AC earthed socket. If in doubt, have the socket checked by a specialist. – The mains voltage and the voltage shown on the rating plate (..Page 11) must be the same. – The connected load and necessary fuse protection are specified on the rating plate. Frost protection / Transport Preparation 1. Empty the condensation container ..page 4. 2. Select any programme using the programme selector. 3. Press the Start/Stop button ..condensation is pumped into the container. 4. Wait 5 min., and then empty the condensation container again. 5. Turn the programme selector to Off. The water tank must not contain any distilled water. If necessary, run the Steam/Refresh programme. 1. Remove all accessories from the drum. The drum must be empty. Make sure that the air inlet remains unobstructed Clean and level Do not install the dryer behind a door or sliding door, which could prevent or restrict opening of the dryer door. This will prevent children from locking themselves in and putting their lives in danger. 2. Do not operate the dryer if there is a danger of frost. 11Technical data ..Dimensions (DxWxH) 60 x 60 x 85 cm (adjustable height) Weight approximately 43.5 kg Max. capacity 7 kg Condensation container 4.0 l Water tank approx. 0.4 l Connection voltage 220-240 V Connected load max. 2600 W Fuse protection 13 A Ambient temperature 5 -35 °C Product number Production number Inside of door The rating plate can be found on the back of the dryer. ..Drum interior light (depending on model) (bulb E14, 25 W) The drum lights up after the door is opened or closed, and after the programme starts, and switches off automatically. Changing the bulb ..page 12. Consumption rates (The value on the label is achieved at the maximum heat setting.) Fabrics/programmes Residual moisture in the fabrics after spinning Drying time** Energy consumption** Cottons 7 kg 13 A 13 A Cupboard Dry* 1400 U/min (50%) 106 min 3.60 kWh 1000 U/min (60%) 124 min 4.20 kWh 800 U/min (70%) 143 min 4.80 kWh Iron Dry* 1400 U/min (50%) 82 min 2.59 kWh 1000 U/min (60%) 98 min 3.28 kWh 800 U/min (70%) 112 min 3.96 kWh Easy-Care 3.5 kg Cupboard Dry* 800 U/min (40%) 42 min 1.35 kWh 600 U/min (50%) 51 min 1.65 kWh * Programme setting for testing in accordance with applicable standard EN61121. ** The values may differ from those specified, depending on the type of fabric, composition of laundry to be dried, residual moisture in the fabric and the amount of laundry being loaded. Fabrics/programmes Drying time Annual energy consumption Cottons 7 kg / 3.5 kg* Cupboard Dry*** 97 min / per cycle 504 kWh / per year *** Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU. Optional accessories (from after-sales service using order number) Washer-dryer stack connection set The dryer can be placed on top of a suitable washing machine with the same width and depth to save space. The dryer must be fastened to the washing machine using this connection set. Connection fittings for condensation outlet The condensation is conveyed directly via a hose. Installation underneath the worktop Instead of the appliance covering plate, you must have a metal cover fitted by a specialist. CZ11390WZ20160WZ20290 12 What to do if... If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales service. We will always find an appropriate solution and will avoid unnecessary visits by engineers. Trust the expertise of the manufacturer and rest assured that the repair will be carried out by trained service technicians using original spare parts. The contact details of your local after-sales service can be found in the enclosed after-sales service directory, or by calling one of these numbers: – GB 0844 892 8989 (Calls from a BT landline will be charged at up to 3 pence per minute. A...

Download now

Please, enter two numbers from picture: