Votes - 1, Average rating: 3 ( )

Manafacture: LG File size: 6.96 mb File name: Language of manual:

• Die Transportsicherungsschrauben mussen vor jedem Transport des Gerats wieder angebracht werden. 4. Die Schraubenbohrungen mit den beiliegenden Kappen verschlie.en. 1 2 3 4 Schraubenschlussel 6 Фиксатор шланга Бак для белья Крепежный ремень мин. 60 см макс. 100 см мин. 60 см макс. 100 см 60 - 100 cm @ 29 roubleshooting guide Symptom Possible Cause Solution • Water supply is not adequate in area • Water supply taps are not completely open. • Water inlet hose(s) are kinked. • The filter of the inlet hose(s) are clogged. • If water leakage occurred in the inlet hose, indicator “..” will be changed red color. • Drain hose is kinked or clogged. • The drain filter is clogged. • Load is too small. • Load is out of balance. • The appliance has an unbalance detection and correction system. If individual heavy articles are loaded (ex. bath mat, both robe, etc.), this system may stop spinning or even interrupt the spin cycle altogether. • If the laundry is still too wet at the end of the cycle, add smaller articles of laundry to balance the load and repeat the spin cycle. • Is the door opened or not completely closed? • Water overfills due to the faulty water valve. • Water level sensor has malfunctioned. • Over load in motor. • Water leaks • The washer experienced a power failure. Check another tap in the house. Fully open tap. Straighten hose(s). Check the filter of the inlet hose(s). Clean and straighten the drain hose. Clean the drain filter. For more detailed information, please refer to “The drain pump filter” on page24 Add 1 or 2 similar items to help balance the load. Rearrange load to allow proper spinning Close the door completely. . If “ ”is not released, call for service. Unplug the power plug and call for service. Close the water tap. Unplug the power plug. Call for service. Call for service. Restart the cycle. T 29 roubleshooting guide Symptom Possible Cause Solution • Water supply is not adequate in area • Water supply taps are not completely open. • Water inlet hose(s) are kinked. • The filter of the inlet hose(clogged. • If water leakage occurred indicator “..” will be • Drain hose is kinked • The drain filter is clogged. • Load is too small. • Load is out of balance. • The appliance has an unbalance detection and correction system. If individual heavy articles are loaded (ex. bath mat, both robe, etc.), this system may stop spinning or even interrupt the spin cycle altogether. • If the laundry is still too wet at the end of the cycle, add smaller articles of laundry to balance the load and repeat the spin cycle. • Is the door opened or not completely closed? • Water overfills due to the faulty water valve. • Water level sensor has malfunctioned. • Over load in motor. • Water leaks • The washer experienced a power failure. Check another tap in the house. Fully open tap. Straighten hose(s). the filter of the inlet hose(s). and straighten the drain hose. the drain filter. For more detailed information, please refer to “The drain pum...

Download now

Please, enter two numbers from picture: