Votes - 2, Average rating: 4 ( )

Manafacture: Sears File size: 1.01 mb File name: 4211cd58-1129-475c-b797-31a40a823c04.pdf Language of manual:

5 Your Range and Its Features ..................................... 6 Cooktop Cooking .................................................... 7, 8 Cooktop Controls ....................................................... 7 Range Control ............................................................. 9 Clock & Timer ............................................................ 10 Burner Ignition ...................................................... 7, 12 Oven Cooking Tips .............................................. 11.13 Broiling ...................................................................... 14 CLEANING The Self-Clean Cycle .......................................... 15,16 Cleaning Tips ...................................................... 17,18 Removable Range Parts ..................................... 15-20 SERVICE What to 0o Before Calling for Service .............. 21, 22 Thermostat Adjustments ......................................... 23 WARRANTY MODELS 36745, 36749 Kenmore MAR29200O USE • CARE • SAFETY MANUAL Recyd_ paper 229C402OPO22-1 SR10232 STABILITY DEVICE • ALL RANGES CAN TIP • INJURY TO PERSONS COULD RESULT • INSTALL ANTI-TIP DEVICES PACKED WITH RANGE • SEE INSTALLATION INSTRUCTIONS REMOVE ALL PARTS FROM THE PLASTIC BAG ATTACHED TO THE BACK OF THE RANGE AND SAVE PACKAGING TAPE. 1) Before placing range In the counter, notice the loca tion of the stability bracket which is already attached to the back ot the range. This location should work for most installations. However, it may be more convenient to hook the stability chain to the unit when the stability bracket is attached to the upper set of holes in the back of the range (See Fig. 1). The upper set of holes are Intended for use with a backsplash kit. If a backsplash kit is being used, the stability bracket can be relocated and put on at the same time as the backsplash kit. If the backsplash is not being used, make sure that there are no structural supports for the countertop which will Interlere with the stability bracket when located in the upper set of holes. 2) Fasten one end of the stability chain to the floor or the wall with the long screw and washer supplied (See Fig. 2). Make certain the screw is going into the wall plate at the base of the wall or one of the studs In the base of the wall (See Fig. 3). Whether you attach the chain to the wall or floor, be certain that the screw Is in at least 3/4" thickness of wood other than baseboard and that there are no electrical wires or plumbing in the area In which the screw could penetrate. Attach the stability chain in a location which will allow the chain to be in line with the bracket side to side as much as possible when attached to the unit. Test to see If the chain is securely fastened by tugging on the chain. 3) Temporarily attach the loose end of the chain to the rear ol the countertop with the tape from the packaging (See Fig. 4). 4) Place the range In the counter cutout leaving just enough room between the back of the range and the wall to reach the stability bracket. 5) Hook the loose end of the chain onto the bracket by slipping the nearest link of the chain into the slot in pulled as tlg ht as possible and that there Is no excess slack In the chain after chain is attached to the bracket. Excess slack in the chain could allow the range to tip over. 6) Slide the range all the way back Into the counter. Once the range is pushed back in place, there will be a small amount of slack in the chain. This is normal. BACKGUARD BRACKET OP_ONAL LOCATION Fig. 1 FACTORY LOCA_ON MAINBACK (Ele_ric modelshown; OpposltesideusedforGas models) CHAIN- WASHER AND SCREW- Fig. 2 CHAIN_ I [ WALL \\ IIP ATE _x I WASHER_ J] / Fig. 3 TAPE Fig. 4 CHAIN the bracket (See Fig. 1), making sure the chain is 1 NEINS28-1 IMPORTANT INSTRUCTIONS FOR YOUR SAFETY SAVE THESE Read all instructions before using appliances, basic safety precautions WARNING: If the Information In this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. --Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. --WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance! • Do not touch any electrical switch; Do not use any phone In your building! • Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions! • If you cannot reach your gas supplier, call the fire department. --Installation and service must be performed by a qualified installer, service agency or the gas supplier. WARNING: L. P. Burner Adjustments The adjustments Inthe Installation Instructions must be made before you try to use your range. It you are using Liquefied Petroleum Gas (bottled gas) all L. P. adjustments in the Installation Instructions must be made be- tore use. If you rrange Is not properly adjusted, llames may be too high, or the range may use too much fuel, release toxic fumes or cook poorly. I...

Download now

Please, enter two numbers from picture: