Votes - 0, Average rating: 0
(
)
)
|
manual abstract
2. To remove the battery, lift it as shown. 3. Carefully lift the SIM card holder from the finger grip of the phone, and open the flip cover. 4. Insert the SIM card, so that the bevelled corner is on the upper right side and the gold-colored contact is facing downward. Close the SIM card holder and press it to lock it into place. Get started 5. Insert the battery into the battery slot. See"Nokia battery authentication guidelines," p. 50. Position the battery so the gold-colored contacts match up with those on the phone. Insert the battery into the battery slot. Snap the other end of the battery into place. 6. Align the back cover with the back of the phone and slide it upwards. Push the back cover up to the top of the phone to lock it. ¦ Charge the battery Warning: Use only batteries, chargers, and enhancements approved by Nokia for use with this particular model. The use of any other types may invalidate any approval or warranty, and may be dangerous. Check the model number of any charger before use with this device. This device is intended for use when supplied with power from the ACP-12 charger. This device is intended to use battery of BL-5C. 1. Connect the charger to a wall socket. 2. Connect the lead from the charger to the connector on the bottom of your phone. Note:Do not touch this connector as it is sensitive for electrostatic discharge. Charging time depends on the charger and the battery used. If the battery is completely discharged, it may take a few minutes before the charging indicator appears on the display or before any calls can be made. For availability of approved enhancements, please check with your dealer. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord. Get started ¦ Switch the phone on and off Warning: Do not switch the phone on when wireless phone use is prohibited or when it may cause interference or danger. Press and hold the power key as shown. If the phone asks for a PIN or security code, enter the code supplied with your SIM card (displayed as ****), and select OK. See also "Access codes," p. 8. ¦ Normal operating position Your device has an internal antenna. Note: As with any other radio transmitting device, do not touch the antenna unnecessarily when the device is switched on. Contact with the antenna affects call quality and may cause the device to operate at a higher power level than otherwise needed. Avoiding contact with the antenna area when operating the device optimizes the antenna performance and the battery life. ¦ Adjust the earpiece volume To increase or decrease the volume during a call, press the right or left scroll key. When adjusting the volume, a bar chart appears in the display indicating the volume level. ¦ Loudspeaker You can use your phone as a loudspeaker during a call. Do not hold the phone to your ear during the loudspeaker operation as the volume may be very high. Your phone 2. Your phone ¦ Keys and connectors Warning: The 4-way navigation keys in this device may contain nickel. It is not intended to come into prolonged contact with the skin. Continuous exposure to nickel on the skin may lead to nickel allergy. • Power key (1) • Earpiece (2) • Loudspeaker (3) • Left, right and middle selection keys (4) • 4-way navigation keys (5) • Call key (6) • End key (7) • Key pad (8) 12345678 • Charger connector (9) • Bottom connector (10) • Headset connector (11) 9 • Eyelet for the wrist strap (12) 10 11 12 Your phone ¦ Standby mode When the phone is ready for use, before you enter any characters, the phone is in the standby mode. The following information is displayed on the screen: • Name of the network or the operator logo (1) • Signal strength of the cellular network at your current location (2) • Battery charge level (3) • Left selection key (4) is Go to in the standby mode. Select Go to to view the functions in your personal shortcut list. Select Options > Select options to view the list of available functions that you can add in the options list. Scroll to the desired function, and select Mark to add the function to the shortcut list. To remove a function from the list, select Unmark. To rearrange the functions on your shortcut list Organize, the function, and Move; then choose the location. • Menu (5) • Names (6) Wallpaper You can display wallpaper, a background picture, when the phone is in the standby mode. See "Display settings," p. 32. Screen saver You can set your phone to display a screen saver when the phone is in the standby mode. See "Display settings," p. 32. Power saving To save power, a digital clock view overwrites the display when no phone function is used for a certain period of time. If you have not set the time, 00:00 is displayed. See "Display settings," p. 32. Your phone Essential indicators You received one or more text, picture, or multimedia messages. See "Read and reply to messages," p. 22 or "Read and reply to an MMS," p. 25. The phone logged a missed call. See "Call log," p. 28. The ph...