Votes - 1, Average rating: 3
(
)
)
|
manual abstract
6619501201 PR|NTED IN JAPAN 6619501201 iV88 TWO YEAR LIMITED WAF_RANTY ON CRAFTSMAN POWER BLOWER 636,796912 For two years from data of purchase, when this POWER BLOWER is maintained° lubricated, and tuned up according to the operating and maintenance instructions in the owner's manua], Sears will repair free of charge any defect in material or' workmanship. This warranty exctudas _alower pipes, spark plug, and air cteaner; which are expandable parts and become worn during normal use. If this POWER 8LOWER is used for commercial or rental purposes, this warranty applies for only 30days from the date of purchase. WARRANTY SERVICE tS AVAILABLE BY CONTACTING THE NEAREST SEARS SERVICE CENTER/DEPARTMENT IN THE UNITED STATES, This warranty applies only while this product is in usa in the United St0tes, This warranty gives you spectflc legal rights, and you may also have other rights which very from state _o state, SEARS, ROEBUCK AND CO. DEPT, 698/731A SEARS TOWER , CHICAGO, 1LLINOIS 60684 INTRODUCTION The Sears Power Blower, Model 636.796912 is a lightweight, high performance 2 cycle two stroke, gasoiine powered blower, which is designed for autumn leaves, driveway and sidewalk sweeping, gutter cleaning, light snow and debris removal. The blower works faster' and more efficiently than rakes or brooms. Excellent balance, a vibration damping system and light weight ensure comfortable, safe and fatigue-free operation. This manual provides instructions for assembly, operation and maintenance for your' unit. Be sure to read this manual before operation. IMPORTANT RULES FOR SAFE OPERATION 1. Gasoline (t) Handle gasoline with care. it is high inflammable° (2) Use proper' gasoline-oil fuel mixture° See P, 4. (3) Refuel before starting work. (4) Do not refuel a hot engine. (5) Avoid spilling fuel or oil. Always wipe unit dry before using° (6) Move at least 3 meters (10 feet) away from the fueling point before starting engine. (7) Always store gasoline in approved container'. 2. Operation (1) Do not operate in unventilated area, (2) Do not allow bystanders in work area. (3) Always wear light clothing. (4) Always wear safety glasses and a face filter mask. Wear ear protectors where possible. (5) Do not touch muffler, spark phJg and rotating parts, (6) Do not run the machine without flexible corrugated pipe and spent pipe or the engine may be damaged, (7) Do not use the machine in such a way that the end of spout pipe may be covered, 3_ Check (1) Always check periodically for efficient and safe operation. (2) Before Storing, drain fuel tank and carburetor. (3) Wash air cleaner element with neutral detergent and dry it well. (4) Remove dust from blower, (5) Tighten bolts further if they are ioose, (6) Replace damaged parts, (7) Always use proper parts for replacement° TABLE OF CONTENTS Page SECT!ON I. TECHNICAL SPECIFICATIONS ................................. 4 SECTION I1, COMPONENT IDENTIFICATION .................................. 4 SECTION Ill, ASSEMBLY INSTRUCTIONS ...................................... 5 SECTION IV, PREPARATION FOR USE ....................................... 5 SECTION V, STARTING THE ENGINE ...................................... 5 SECTION Vl, STOPPING THE ENGINE ........................................ 6 i SECTION VII_ OPERATING THE POWER BLOWER ............................. 6 SECTION VIII, CHECK AND MAINTENANCE .................................. 6 SECTION IX, STORAGE AFTER USE ........................................ 7 SECTION X, TROUBLESHOOTING .......................................... 8 SECTtON XI. SPARE PARTS LIST ........................................... 10 t, TECHNICAL SPECIFICATIONS Model 636.796912 Dimensions Weight, dry Fuel capacity Engine Type D isplacement Ignition system Carburetor Spark plug Spark plug gap Starker Max, air volume Max. air speed Muffler Fuel *Specifications LxWxH=450x490x495mm(17.7in. x19.3in, x19,5in.) 8 kg (17.6 Ibs,) 2,4 litre (0.634 gel) Air cooled two stroke 37,7 cc (23 cuing) : Solid State Ignition Float type S.T,D, 360942 0,,6 0,7 mm (,024 -,028") Automatic recoil : 11 rn3/min, (385 cu,fto/min,.) 83 m/sec, (273 ft/sec.) Spark arrester Fuel-Oil Mix Between 20 and 25 to 1 For the first twenty hours, use the mixing ratio of between 15 and 20 to 1 are subject to change without notice, I1o COMPONENT IDENTIFICATION Spout Pipe-_ Straigh% Pipe Fuel Tank Cap, Straight Pipe Jr-L_ U Recoil Thro_le Air Cleaner Lever )ark Plug _ _Wing Swivel Joint Hose Band Pipe / Bent Tube Figure 1 III.ASSEMBLY INSTRUCTIONS I, Attach Note: throttle Ensure lever that to the machine_ {Fig_ 2) the lever can be operated normally 'L Figure 2 2. Attach shoulder straps to the machine {Fig_ 3) Note: Adjust the straps to fit your body. Figure 3 3o Assemble blower pipes, (Fig 1) Note; Assemble pipes securely or they may separate , while operating. IV. PREPARATION FOR USE 1, Ensure again that all parts are assembled normally and that aft nuts and bolts are properly tightened 2, Adjust shoulder straps to fit...