Votes - 2, Average rating: 4.5 ( )

Manafacture: Euro-Pro File size: 1.47 mb File name: 1104HB-HG-HP-HV-HW_REV_0206A.pdf Language of manual:

Rethread the machine. - The needle is threaded incorrectly. Make sure that the needle is threaded from left to right. - The needle is not properly inserted. - The batteries are installed backwards. Check the placement diagram in the battery compartment and reinstall. Caution: When removing fabric after sewing, first turn the hand wheel to raise the needle to the highest position. Then lift the presser foot and remove the fabric. This will prevent the needle from bending. 3. The sewing machine runs slowly. - Used and new batteries are mixed together. Replace using all new batteries. - Use only 4 AA batteries. 4. The sewing machine stops sewing. - Very heavy fabric or too many layers of fabric will force the sewing machine to stop. - The thread is tangled in the lower bobbin. Stop the machine and cut the tangled threads to clear it from the machine. Rethread both the bobbin and the needle. - Poor quality stitching, refer to “Adjust Thread Tension” section. - The sewing machine should run approximately for two (2) hours with new batteries under normal sewing conditions. Sewing heavy fabric requires more power, so it will reduce the running time of the batteries. 10 NEEDLE REPLACEMENT Caution: Remove the batteries and/or disconnect the AC/DC adapter before starting to replace the needle. 1. Turn the hand wheel to raise the needle to its highest position. 2. Hold the old needle and loosen the needle clamp screw. Remove the old needle and discard responsibly. 3. Insert the new needle into the clamp with the flat side toward the right. Be sure to push the needle all the way up into the needle clamp before tightening the needle clamp screw. 4. Tighten the needle clamp screw. SEWING SLEEVES This sewing machine has been designed to sew sleeves or any narrow openings in garments. 1. Lift the presser foot. 2. Position the garment over the sewing arm and between the platform and the base. 3. Lower the presser foot and follow the regular sewing instructions. CAUTION: 1. Don’t press the On/Off button at the same time as the foot control. 2. Don’t use the batteries and the AC/DC adapter at the same time. 3. Make sure that the batteries are inserted in the correct position. 4. Don’t keep the machine running for too long. 5. Sewing some very stretchy fabrics might result in skipping stitches - use a stretch needle. 6. It is not recommended for use on sewing fabrics such as terrycloth. 7. Use AC/DC adapter (6V, 1 A) or 4 AA alkaline batteries (1.5 V) only. 9 NAME OF PARTS Spool Stitch Length -Adjustment & Reverse Dial Bobbin Winder Button On/Off Button Speed Button Dressmaker Thread '*•----- Needle Thread Take-Up Lever ake-Up er Tension Dial Thread Cutter Needle Presser Foot Bobbin Winder -Lever Accessory Storage -Compartment AC/DC Adapter Port , (6 V, 1A) - Presser Foot Lifter Light Switch Needle Clamp Screw Bobbin Cover ■Release Button 2 ACCESSORIES I— Foot Pedal AC/DC Adapter Bobbins (x2), Thread Spoo...

Download now

Please, enter two numbers from picture: