Votes - 4, Average rating: 3.8 ( )

Manafacture: GBC File size: 356.31 kb File name: Language of manual:

This could hurt you. ELECTRICAL SAFEGUARDS • Unplug your shredder before moving it, emptying the shred bag, or when it is not in use for an extended period of time. • Do not operate with a damaged power supply cord or plug, after it malfunctions, or after it has been damaged in any manner. • Do not overload electrical outlets beyond capacity as this can result in fire or electrical shock. • The socket-outlet should be installed near the equipment and shall be easily accessible. • Do not alter attachment plug. The plug is configured for the appropriate electrical supply. AWARNING Co NOT ænsol d.ster= or :lei.ner= NO I r.ptay a-v. thlno inlc t'r- fihrrrlrl.''. =crçigt îubE^rceE cm te explosive. 3.0/4.0 5020S/5230S Installation/Operation SET UP-FIGURE 2.A. A Caution! Shredders are heavy equipment (see “Shredder Head Weight" in the “Specifications" section of this Manual). To insure proper installation and avoid injury GBC recommends that two people set up this unit. 5200 Series Models Only: To protect against damage your shredder has been shipped in two parts, the shredder head (A) and the cabinet (B). 3200-4200 Series Models Only: To protect against damage your shredder has been shipped in three parts, the shredder head (A), the cabinet (B) and the casters (C). FIGURE 1. Begin set up by lying the cabinet on its back and inserting the casters into the sockets at the four corners of the cabinet bottom. Once the casters are fully inserted turn the cabinet upright. All Models: FIGURE 2.A. A Caution! Use care not to pinch your fingers between the shredder head and cabinet. Handle shredder head as illustrated. FIGURE 2.B. Open the cabinet door fully, lift the shredder head by the outside front and back edges using two people on each side. Angle the shredder head slightly downwards from the front and lower onto the cabinet. Once properly installed, a uniform gap of approximately a 1.6mm will be visible from the front. FIGURE 3. Remove the wire bag rim and place one of the starter bags onto the rim. Slide the rim with bag back into the cabinet. Close the cabinet door. Your shredder is ready for use! OPERATION-figure 4. Connect power cord to an appropriate power source. Press the rocker switch (A) to the on "I" position. When the shredder is properly set up with cabinet door fully closed the Power On light (B) will illuminate. You are now ready to shred! To shred simply insert paper into the throat of the unit. Once your document has activated the Automatic On switch the unit will start and then will stop once your document is shredded. BIN FULL ES In order to prevent shreds from backing up into the cutters and jamming your shredder this unit features an automatic bin full shut off. Once the shred bin is full the unit will shut off automatically and the Bin Full light (C) will illuminate. You can now either compact the shreds and continue shredding, or empty the shred bag. NOTE: For safety reasons, whenever the cabinet door has been opened this unit will not operate until the door is closed and the unit is switched off and then back on. DOOR AJAR p Your shredder is equipped with a safety interlock which will not allow the unit to operate if the cabinet door is open. The Door Ajar light (D) will illuminate if your cabinet door is not fully closed. OVERLOAD R If too much paper is inserted into the throat of the unit the shredder will sense an overload and shut off automatically to avoid unnecessary motor heating and the Overload Light (E) will illuminate. To clear the overload, switch the unit to Reverse "R" mode until the paper is clear of the throat area. Switch your unit back into the Power On position, separate your pages into smaller sets and shred....

Download now

Please, enter two numbers from picture: