4 Additional Safety Instructions for Sandblasters ......................................................................... 6 SECTION 2: SET UP........................................................................................................................ 7 Set Up Safety............................................................................................................................. 7 Items Needed for Set Up .....................................................................

We will then issue you a “Return Number,’’ which must be clearly posted on the outside as well as the inside of the carton. We will not accept any item back without this number. Proof of purchase must accompany the merchandise. The manufacturers reserve the right to change specifications at any time because they constantly strive to achieve better quality equipment. We make every effort to ensure that our products meet high quality and durability standards and we hope you never need to use this

The large size of the foot pads distributes the weight of the machine to reduce strain on the floor. Machine mounts for this machine use Grizzly Model G7158. Figure 7. Typical lag shield anchor and lag bolt. Figure 8. Typical anchor stud. Figure 9. Machine mount example. G0489 Metalworking Sander -13- Mounting Sander This step may require three people to complete— two to lift and hold the sander in place, and one person to install the hardware. Components and Hardware Needed: Qty Sleeve

REVISED OCTOBER,1999. PRINTED IN U.S.A. Table Of Contents PAGE 1. SAFETY SAFETY RULES FOR ALL TOOLS ......................................................................3-4 ADDITIONAL SAFETY INSTRUCTIONS FOR SANDERS ......................................5 2. CIRCUIT REQUIREMENTS 110V OPERATION ....................................................................................................6 FUSING ...............................................................................................

See Page 26 for complete instruction on rewiring the sander. To attach the motor to the stand: Attach the motor to the stand with (4) M8-1.25 x 20 cap screws, (4) M8 flat washers, (4) M8 lock washers, (4) plastic disc pads and (4) M8-1.25 hex flange nuts (Figure 6). Note–The plastic disc pads should be installed between the motor and the stand. Stand Plastic Disc Pads (One Under Each Corner) Motor Figure 6. Attaching motor to stand. Dust Hood Brackets The two dust hood brackets are identical, bu

....................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

#PC7907 PRINTED IN TAIWAN ..........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

Keep loose clothing rolled up and long hair tied up and away from machinery. Table Movement Adjusting Feed Rate T able height can be adjusted manually or with the digital key pad and motor (see Figure 15). Manual Table Movement: Turn the handwheel located under the front of the infeed table for manual table positioning. Motorized Table Movement: Press the TABLE UP or TABLE DOWN key once for motorized table positioning in 0.005" (0.1mm) increments. Numerical Key Pad: Push the keys to enter

The owner of this machine MUST maintain the original location and readability of the labels on the machine. If any label is removed or becomes unreadable, REPLACE that label before using the machine again. Contact Grizzly at (800) 523-4777 or to order new labels. -44- G3622-23/G3708/G4787-88 industrial Buffer

#BL7827 PRINTED IN TAIWAN ..........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................