Votes - 4, Average rating: 4.5 ( )

Manafacture: Porter-Cable File size: 343.42 kb File name: f9318be0-afcf-4dea-ae5e-2e1aa0b61674.pdf Language of manual:

Disconnect the tool from the air supply before lubricating or changing abrasive disc. . Lubricate tool, see “Maintenance” section in this manual. . Place abrasive disc onto sander pad. See "To Install Abrasive Disc" paragraph in the "Maintenance" section. . Connect tool to air hose of recommended size. NOTE: The use of a quick connect set makes connecting easier. IMPORTANT: The use of air filters and air line lubricators is recommended. To use: . Turn air compressor on and allow air tank to fill. . Set the air compressor’s regulator to 90 PSI. This tool operates at a maximum 90 PSI pressure. . Depress trigger to operate tool. ASSEMBLY IMPORTANT: Line pressure or hose inside diameter should be increased to compensate for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D. and fittings should have 1/4” NPT thread. OPERATION ASSEMBLY IMPORTANT: Line pressure or hose inside diameter should be increased to compensate for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D. and fittings should have 1/4” NPT thread. OPERATION . Release trigger to stop tool. . This tool is equipped with an air valve control lever to adjust RPM speed from 0-12000. It is recommended to operate the tool with the air valve control at the maximum setting for the best tool performance. . When job is complete, turn the air compressor off and store as described in the air compressor operator manual. Tips . Begin sanding with an abrasive grit sandpaper coarse enough to remove the high spots. Progress to a finer grit sandpaper until the desired finish is obtained. . Never change from coarse grit sandpaper to a very fine grit sandpaper, always progress gradually to the finer grit. Air Inlet Trigger Sander Pad Air Valve Control Lever Without Vacuum Option Air Inlet Trigger Sander Pad Air Valve Control Lever Vacuum Exhaust With Vacuum Option D29847 6- ENG Lubrication Air tools require lubrication throughout the life of the tool. The air motor and bearing uses compressed air to power the tool. Because moisture in compressed air will rust the air motor, you must lubricate the motor daily. An inline oiler is recommended. To lubricate the air motor manually: . Disconnect the tool from the air supply holding it so the air inlet faces up. . Depress the trigger and place one to two drops of air tool oil in the air inlet Depressing the trigger helps circulate oil in the motor. NOTE: Use SAE #10 weight oil if air tool oil is not available. . Connect the tool to an air source, cover the exhaust end with a towel and run for a few seconds. NOTE: Any excess oil in the motor is immediately expelled from the exhaust port. Always direct exhaust port away from people or objects. Failure to lubricate the tool at the air inlet will void your warranty. ACCESSORIES Models equipped with the vacuum option can be used with remote vacuum systems, see "Specifications" for listing of models. To attach tool to vacuum system use Porter-Cable vacuum hos...

Download now

Please, enter two numbers from picture: