Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
manual abstract
5 Click START. TV MONITOR SET TV IR SET START Sony TV OTHER TV 6 When “PUSH YOUR COMMANDER” appears on the TV screen, press the button on the TV's remote that corresponds to the highlighted control button. Programme the button used to turn ON your TV (e.g., CH0, CH1, CH+, etc.) as “CHANNEL 0”. EXIT TV IR SET RETURN TV IR SET CHANNEL 0 POWER OFF PUSH YOUR COMMANDER CODE CLEAR WIDE TV DISPLAY MODE When programming the IR code, point the remote at the IR sensor on the amplifier from a distance no greater than 10 cm (4 inches) and hold down the button on the remote for about 5 seconds until the instruction “RELEASE YOUR COMMANDER” appears. IR sensor Keep the remote pointed horizontally at the IR sensor until the code is programmed. If you tilt or move the remote during the programming process, the IR code may not be programmed correctly. 7 Repeat this procedure for the remaining buttons that appear on the TV screen. If an IR code was not programmed correctly, the IR code setting indicator will flash. Registering Audio/ Video Equipment Registering Sony audio/video equipment If your Sony audio and video equipment can be controlled by an infrared remote, simply connect them to the jacks shown on the following table, registration is unnecessary. Amplifier jacks Equipment to be connected VIDEO 1 Sony VTR 3 (VHS) VIDEO 2 Sony VTR 1 (BETA) VIDEO 3 Sony VTR 2 (8 mm) LD Sony LD player SATL Sony Satellite decoder TUNER Sony Tuner DAT/MD Sony DAT deck CD Sony CD player (CD 1) TAPE Sony Tape deck MONITOR Sony TV (via its AV 1 jack) The following cases require registration of Sony products • When connecting a Sony MD deck to the DAT/MD jacks. • When connecting a Sony audio product with CONTROL-A1 compatibility. • When connecting a Sony product to jacks other than those specified in the previous table (e.g., when connecting a Sony LD player to the VIDEO 3 jacks). • When exchanging non-Sony audio or video equipment with a Sony product. Notes • If your VCR has a COMMAND CODE selector switch (for VTR 1, VTR 2, or VTR 3), set the switch to the applicable setting. • If your CD changer has a COMMAND MODE selector switch (for CD 1, CD 2, or CD 3), normally it should be set to “CD 1”. However, if your CD changer has VIDEO OUT terminals, set the command mode to “CD 2” or “CD 3” (“CD 3” should only be used when making CONTROL-A1 connections). Registering non-Sony audio/video equipment 1 Click FUNCTION in the main menu. 2 Click IR SET. FUNCTION SELECT VIDEO 1 DAT/MD CDVIDEO 2 TUNERVIDEO 3 PHONOL D TAPESATL MACRO 1 MACRO 2 EXIT IR SET 3 Click the appropriate function. EXIT VIDEO 1 Sony VTR3 Sony VTR1 Sony VTR2 SATL DAT/MD Sony DAT CD Sony CD1 TAPE Sony TAPE Sony DBS Sony LD IR CODE SETTING VIDEO 2 VIDEO 3 LD RETURN TUNER Sony TUNER 4 Click “Sony” for a Sony product or OTHER for a non-Sony product. EXIT OTHERMAKER IR CODE SETTING RETURN Sony OUTPUT IR If the programme source is a Sony product The IR codes are programmed automatically and registratio...