Votes - 4, Average rating: 4.5
(
)
)
|
manual abstract
When switched into bridged mono mode, it shall deliver at least 200 watts into a 16 ohm load or 320 watts Into an 8 ohm load. The amplifier shall be immune to damage from shorted, open, or mismatched loads. The amplifier shall have a gain of 26dB ± ,5dB per channel and an input sensitivity of 1.4 Volts + 2% for full rated output. Frequency response shall be 10Hz to 20kHz ± 5dB. It shall be stable into any load including pure capacitors and inductors. Hum and noise shall be at least llOdB below full output and SMITE intermodulation distortion shall be less than .01% at lull output. The amplifier shall have rear panel switching for mono and bridging modes and rear mounted level controls. The inpuls shall be balanced brldg Ing type with male and female XLR type connectors as well as 1/4" phone jacks. A three-color LED lype indicator shall be employed to show the power level of each channcl and self contained forced air cooling shall be used. The power output devices shall be of the Lateral MOS-FET type. The amplifier shall weigh 321b. nel and mount in a standard 19 inch rack using two spaces [3.5 ' high I. The power requirement shall be 110-125VAC, S0-60Ilz, The power amplifier shall be an Ashly FET- I000M, Ashly Model 1000C The power amplifier, being of two channels, shall deliver a minimum power of 100 watts per channel into 8 ohm loads or 160 watts per channel into 4 ohm loads with both chan nels operating. When switched into bridged mono mode, it shall deliver at least 200 watts Into a 16 ohm load or 320 watts into an 8 ohm load. The amplifier shall be immune to damage from shorted, open, or mismatched loads. The amplifier shall have a gain of 26dB ± ,5dB per channel and an input sensitivity of 1.4 Volts ± 2% for full rated output. Frequency response shall be 10Hz to 20kllz ± .5dB, It shall be stable into any load including pure capacitors and Inductors. Hum and noise shall be at least llOdB below full output and SMITE inlermodulatlon distortion shall be less than .01% at full output. The amplifier shall have rear panel switching for mono and bridging modes and rear mounted level controls. The inputs shall utilize 1 /4" phone jacks as well as terminal/barrier input strips. Self contained forced air cooling shall be used. The power output devices shall be of the Lateral MOS-FET type. The amplifier shall weigh 321b. net and mount in a slandard 19 inch rack using two spaces (3.5" high). The power requirement shall be I10-125VAC, 50-60HZ. The power amplifier shall be an Ashly FET- 1000C. ASHLN Since 1972 © 1990 Ashlv Audio To provide maximum flexibility, Ashly offers two variations in our FET Power Amplifiers: The FET-1000M (top) features XLR and 1/4” inputs. The FET-1000C (bottom) utilizes Barrier Strips and 1/4" inputs....
Other models in this manual:Receivers & Amplifiers - FET-1000C (564.86 kb)