Votes - 2, Average rating: 3
(
)
)
|
manual abstract
. Have the module checked by a qualified service engineer before using it again. . Do not use liquid or aerosol cleaners to clean this unit. Always unplug the power to the device before cleaning. 1.3 Regulatory Notices Federal Communications Commission (FCC) This equipment has been tested and found to comply with Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Any changes or modifications made to this equipment may void the user’s authority to operate this equipment. 1.4 Introduction The Avenview C-3GHDSDI-HDMI provides a cost effective way to convert 3G/HD/SD-SDI signal to HDMI compliant format. The conversion between SDI and HDMI is pure digital and guarantees no loss transformation for both audio and video. Plus, with up to 8 channels audio support, 7.1 channel or 5.1 channel audio becomes available. The C-3GHDSDI-HDMI also provides 2 low jitter and re-clocked outputs for daisy chain or multiple monitors. - Supported 3G formats(SMPTE 425M, Level A): 1080p @50/59.94/60Hz (4:2:2) - Supported high-definition (HD) formats: 1080i @50/59.94/60Hz, 1035i @50/59.94/60Hz, 720p @50/59.94/60Hz - Supported standard-definition (SD) formats: NTSC @59.94Hz, PAL @50Hz - Auto 3G/HD/SD-SDI detection - Two equalized and re-clocked loop outputs - External DIP Switch Configuration 1.5 Package Contents Before you start the installation of the converter, please check the package contents. - C-3GHDSDI-HDMI x 1 - Power Adapter (+5VDC, 4A) x 1 - User’s Manual x 1 1.6 Before Installation . Put the product in an even and stable location. If the product falls down or drops, it may cause an injury or malfunction. . Don’t place the product in too high temperature (over 50°C), too low temperature (under 0°C) or high humidity. . Use the DC power adapter with correct specifications. If inappropriate power supply is used then it may cause a fire. . Do not twist or pull by force ends of the optical cable. It can cause malfunction. 1.7 Panel Description 1.7.1 Front Panel 1 2 3 4 1. 3G/HD/SD-SDI Input 2. Lock LED 3. 3G/HD/SD-SDI Loop Out 1 4. 3G/HD/SD-SDI Loop Out 2 1.7.2 Rear Panel 1 2 1. HDMI Output 2. 5V Power Jack 1.7.3 Bottom Panel (DIP SWITCH) A 4-pin DIP switch is used for user interface, and users can access this switch from the bottom of the unit. Output formats, video patterns, SD Pedestal, SD Wide, PAL mode, YPbPr / RGB, SD component or SD composite, YC on/off etc. PIN # 1 2 3 4 OFF . HDMI Mode 7.1 Channel Audio Group 1 & 2 Audio Mute OFF ON . DVI Mode Stereo Audio Group 3 & 4 Audio Mute ON 1. C-3GHDSDI-HDMI mainly checks the audio channel in audio group 1&2 or 3&4. Please adjust DIP switch pin 3 for setup. 2. Some HDMI equipped TV may not be able to decipher multiple channel audio, and therefore set DIP switch pin-2 to ON(.) to get stereo audio work and then check if multiple channel support is available. 3. While DIP Switch pin-4 is set to OFF(.), 3G Level B will be automatically converted to Level A. 4. C-3GHDSDI-HDMI supports only audio sample frequency 48kHz. 5. While stereo audio is chosen, CH 1 & 2 of Group 1 or 3 are output. Section 2: Specifications Item Description Units C-3GHDSDI-HDMI Unit Description 3G/HD/SD-SDI to HDMI Converter SDI Standards 3G-SDI, HD-SDI, SD-SDI Auto 3G/HD/SD-SDI Detection Yes Video Bandwidth 3G: 1080p @50/59.94/60Hz (4:2:2) HD: 720p @50/59.94/60Hz, 1035i @50/59.94/60Hz, 1080i @50/59.94/60Hz SD: NTSC @59.94Hz, PAL @50Hz Input Signal 3G-SDI: SMPTE 424M/425M HD-SDI: SMPTE 292M, 296M SD-SDI: SMPTE 259M Output Signal HDMI Audio Mode 7.1 / 5.1 / Stereo Eye Pattern Characteristics Extra low alignment jitter 0.05.i at HD Cable Equalization 3G-SDI: up to 60m (200 feet) HD-SDI: up to 150m (500 feet) SD-SDI: up to 300m (1000 feet) Loop Out 2 equalized and re-clocked SDI Loop Outs Audio Support Yes Input BNC x 1 (SDI) Output HDMI x 1 BNC x 2 (SDI) BNC Connector 3G 75. inter-locked socket HDMI Connector Type A (19 pin female) DIP Switch 4 pin (output format / audio format / audio group / 3G level) Dimensions (L x W x H) 6.9” X 4.7” x 1” Power Supply 5V 4A DC Power Consumption 3 Watts (max) Environmental Operating Temperature 32. ~ 104.F (0. to 40.C) Storage Temperature -4. ~ 140.F (-20. ~ 60.C) Relative Humidity 20~90% RH (no condensation) 2.1 Supported Resolutions 3G-SDI Input 1080p @ 60/59.94/50Hz C- SMPTE 425M (4:2:2) HD-SDI Input 720p @ 50Hz SMPTE 296M -3 720p @ 60 / 59.94Hz SMPTE 296M -1, -2 1080i @ 25Hz SMPTE 274M -6 1080i @ 30 / 29.97Hz SMPTE 274M -4, -5 1080p @ 24 / 23.98Hz SMPTE 274M -10, -11 1080p @ 25Hz SMPTE 274M -9 1080p @ 30 / 29.97Hz SMPTE 274M -7, -8 SD-SDI Input NTSC PAL B, D, G, H, I avenview-logo-whiteBG_Final.png Disclaimer While every precaution has been taken in the preparation of this document, Avenview Inc. assumes no liability with respect to the operation or use of Avenview hardware, software or other products and documentation described herein, for any act or omission of Avenview concerni...