Votes - 4, Average rating: 4.5
(
)
)
|
manual abstract
Move antenna 12” away from unit for best reception. b) Extend © FM Antenna (on back of unit) fully for best reception. Do not strip, alter or attach to other antennas. Tuning and Playing the Radio a) Press the © Radio Button to select radio play mode. Press as needed to select AM, FM1 or FM2 radio band. b) Turn the Set Wheel to tune radio to a desired station. c) To memorize the current station as a preset, press and hold Q Preset Button 1,2,3 or 4. Repeat steps a,b,and c to preset up to 12 stations (4 AM, 8 FM). To listen to a preset station at any time, simply press the desired preset button. d) Turn the Q Volume Wheel to adjust ¡H8 volume up or down. e) Press the EQ Button to select Treble, Bass or Balance. Turn the Set Wheel to adjust settings. EQ settings for iPod and radio mode are independent. f) Press © Alarm Reset/Power Off Button to turn iH8 and iPod off. Using the Line-in and Line-out Jacks a) An audio patch cord comes with the ¡H8. Use it to play nondocking IPods or other audio devices through the ¡H8 © Line-in Jack (one end In the device’s line out or headphones jack, the other In the ¡H8 line In jack). Make sure there is no IPod docked in the iH8 when using the line-in jack. Press the iPod Button. b) Use the © Line Out Jack to connect the ¡H8 to the line-in jack of other audio devices such as a tape recorder or amplifier. The Volume Wheel of the ¡H8 does not control line-out volume (adjust on attached device Instead). The Line Out Jack Is not recommended for headphones. Using Sleep Mode Sleep mode lets you sleep to your IPod or the radio, gradually lowering the volume until the unit shuts off at the selected time. a) Press the © Sleep Button to select an amount of time before the ¡H8 will turn off: 120, 90, 60, 30 or 15 minutes. b) Turn the Volume Wheel to set the sleep volume (this volume setting is separate from your standard volume setting). Using the Dimmer a) Press the © Snooze/Dimmer Button during normal operation to adjust brightness of LCD display. Using the optional Extension Speaker (sold separately) a) An optional extension speaker Is available for the IH8 (sold separately). Use It to expand the stereo field. Plug the Extension Speaker into the Ext. Speaker Jack located on the back of the iH8. Place the speaker as far as possible from the unit for best stereo sound. Press the Power Button on the Extension Speaker. This will disable the right speaker on the main unit and send the signal to the extension speaker. You’re now ready to enjoy expanded stereo sound Replacing iH8 Backup Batteries Install/Replace Backup Battery The ¡H8 uses a backup battery system to provide continuous alarm operation and clock settings In the event of a power failure. If the Battery Low Icon located on the left of the display is flashing, It is time to replace the backup batteries. Please make sure the AC adaptor is connected, otherwise all settings may be lost during battery replacement. Open the battery compartment cover located on the bottom of the unit. Insert 2 “AA” batteries as indicated. We recommend the use of alkaline batteries for longer life. Batteries information: • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium) batteries. 4 Using The Remote Control Unit The Remote Control controls basic functions on the iH8 and certain iPod® functions when the iPod® is docked in the iH8. For best results, use the remote control within 12 feet of the unit. Turns iH8 ON or OFF....................Power On/Off Alarm or reset alarm when Reset Button alarm is sounding Selects iPod and...............iPod Play/Pause Button plays track. In play mode, press to pause Mutes volume..................................Mute Button Cycles through AM..................Presets Select Button or FM radio presets Snooze mode when.................Snooze/Dimmer Button alarm sounds, otherwise dims display Skip to previous or next track when I Button.............iPod Is playing, or HOLD to scan current playing track. In radio mode, ► Button...... press to tune stations. HOLD to scan radio stations. Volume - Button.....Lowers volume level Volume + Button.....Raises volume level EQ Button..............Set Treble, Bass and Balance settings for best sound Radio Button..........Selects Radio function, AM and FM1 and FM2 radio bands Install/Replace the Remote Control Batteries The remote control batteries are already installed at the factory. When the remote control stops operating or its range seems reduced, replace the batteries with new ones. 1. The battery door Is located on the back end of the unit. 2. Press to release the battery door latch. 3. Insert one “CR2032” 3-volt lithium batteries. Make sure the polarity (the + and - side of the battery) is correct. 4. Replace the battery holder back in the remote control. NOTE: PLEASE DISCARD BATTERIES PROPERLY 5 A Consumer Guide to Product Safety IMPORTANT SAFETY INSTRUCT...