Votes - 2, Average rating: 4 ( )

Manafacture: Sony File size: 326.65 kb File name: 2677266111.pdf Language of manual:

4 Release TIME ZONE to confirm. Notes • Configured time at the factory is not daylight saving time (summer time). If you are on daylight saving time, refer to “To change the display to the daylight saving time (summer time) indication” to active the summer time function. • During the shipment and your first use, a clock error may occur. In this case, refer to “Setting the Clock” to set the correct time. Setting the Clock Set the clock according to the following steps. 1 Plug in the unit. 2 Press DST/CLOCK for a few seconds until a beep sounds. The hour starts to flash on the display. 3 Press + or – until the correct hour appears. To set the current time rapidly, hold down + or –. 4 Press DST/CLOCK once. 5 Repeat steps 3 and 4 to set the minute. Two short beeps sound, “:” starts flashing, and the clock starts from 0 seconds. • The clock system varies depending on the model you own. 12-hour system: “AM12:00” = midnight 24-hour system: “0:00” = midnight • While setting the clock, you must perform each step within 65 seconds, or the clock setting mode will be cancelled. • To set the current time from zero seconds, press DST/CLOCK at the correct second in step 5. To change the display to the daylight savings time (summer time) indication Press DST/CLOCK. “ ” appears and the time indication changes to summer time. To deactivate the summer time function, press DST/CLOCK again. Setting the brightness of the backlight Select BRIGHTNESS to HIGH or LOW for the display, according to your preference. Operating the Radio 1 Press RADIO ON to turn on the radio. 2 Adjust volume using VOLUME. 3 Select BAND. 4 Tune in to a station using TUNING. To turn off the radio Press RADIO OFF/ALARM RESET. Improving the reception FM: Model for Canada: The AC power cord functions as an FM antenna. Extend the AC power cord fully to increase reception sensitivity. Model for other countries/ regions: Extend the FM wire antenna fully to increase reception sensitivity. AM: Rotate the unit horizontally for optimum reception. A ferrite bar AM antenna is built-in to the unit. Do not operate the unit over a steel desk or metal surface, as this may lead to interference of reception. Setting the Alarm This unit is equipped with a dual alarm function, so you can set the alarm time for two different occasions — ALARM A and ALARM B. Furthermore, you can also set an additional two times for weekends. When you select Weekend mode, the set alarms for weekend are activated automatically, and the display color of the alarm window turns green. This unit is also equipped with 3 alarm sounds—radio, buzzer, and melody*. * Melody: Weekday mode— “Morning” from “Peer Gynt,” by Griegsuite No.1, Op.46 Weekend mode— “Four seasons: Spring” by Antonio Lucio Vivaldi Notes • Before setting the alarm, make sure to set the Clock (see “Setting the Clock”). • The factory setting alarm time is “PM 12:00” or “12:00”. • To set the radio alarm, first tune in to a station and adjust the volume (see “Operating the Radio”). • The volume of the buzzer and melody cannot be adjusted. To set the alarm mode (weekday/weekend) You can select the alarm mode to either weekday or weekend. Press WEEKEND repeatedly until the desired alarm mode is selected. If you select the Weekend mode, “WEEKEND ” appears on the display. To set the Alarm Time 1 Press WEEKEND to select the desired alarm mode. 2 Press ALARM SET A or ALARM SET B. Alarm time appears on the desired display. Example: Display window when you set weekend and alarm A. 3 Turn ALARM TIME SET + or – to set the desired time. Each turn of ALARM TIME SET + or – changes the indication by 1 minute. If you turn and hold ALARM TIME SET + or –, the alarm time goes forward (or backward) by 1 minute up to 10 minutes, and then by 10 minutes increments. • To change the alarm time when the alarm is already set, perform step 3 only. • If the same alarm time is set for both alarm (alarm A and B), the alarm A takes priority. 2-677-266-11(1) Operating Instructions Mode d’emploi Bedienungsanleitung (Ruckseite) Manual de instrucciones (en el reverso) © 2006 Sony Corporation Printed in China TIME SET CLOCK SLEEP NAP RADIO DST ALARM RESET RADIO RADIO BUZZER MELODY TIME ZONE WEEKEND SLEEP NAP RADIO BUZZER MELODY ALARM SET ON/OFF MODE ALARM SET ON/OFF MODE A B HIGH ALARM BAND TIME SET TUNING AM FM VOLUME LOW BRIGHTNESS PUSH ALARM TIME SET WEEKEND TIME ZONE CLOCK DST WEEKEND To set the alarm sound 1 Keep pressing ALARM SET A or ALARM SET B for a few seconds until a beep sounds. The alarm time appears and alarm icon flashes on the display. 2 Each turn of ALARM TIME SET + or – changes the indication on the display as follows: RADIO BUZZER MELODY 3 Press ALARM SET A or ALARM SET B again. Two beeps sound to confirm the setting. Note While setting the alarm sound, you must perform each step within 65 seconds, or the clock setting mode will be cancelled. To doze for a few more minutes Press SNOOZE/SLEEP OFF. The sound turns off but will automatically come on again af...

Download now

Please, enter two numbers from picture: