Votes - 2, Average rating: 3.5
(
)
)
|
manual abstract
t 1. Verify opening is within following dimensions: A, Height 52mm-53mm (23/64" - 2 3/32") 8, Width 182mm-184mm (75/32“- 71/4*) 2. If opening is less, careful) file to exact size required (DO NOT OVER FILE). 3. Remove din sleeve from radio and place Into opening. 4. Bend tabs outward to lock sleeve Into dash. 5, Pre-wire radio. Slide radio into din sleeve until it locks into place. Note: Use either rear bushing or perforated strap to secure rear of radio. RADIO REMOVAL (IF NECESSARY) 1. Unsnap trlmrlng on face of radio, 2. Insert removal tool in slotted holes on sides of radio until bottomed. Spread tools outward slightly and pult radio toward you. Remove tools and slide radio fully out. BEND TABS OUTWARD QUICKIE BOLT SNAP CLIPS FIG. 1 RADIO REMOVAL TRIMBEZEL (INSTALLED ON RADIO) REMOVAL TOOL USE EITHER BUSHING OR PERFORATED STRAP TO SUPPORT REAR OF RADIO \U } DASH PANEL...
Other models in this manual:Radios - IM-100 (187.11 kb)
Radios - IM-300 (187.11 kb)