Votes - 3, Average rating: 3.7
(
)
)
|
manual abstract
...... Maintenanc e • Place the unit away from sources of direct sunlight or excessive heat. • Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as Benzine, thinner or similar materials can mar the surface of the case. Setting Up This unit has a Clock which is preset at the factory. It takes just a few steps to match the clock setting to where you live. 1. Depending on your location and whether or not Daylight Saving Time (DST) is in effect, set the DST Switch located on the bottom of the unit to +1 or -1 to adjust the time forward or backward one hour. 2. Press and hold the Time Zone Button located on the bottom of the unit for approx. 2 seconds until the Time Zone Indicator at the lower part of the display shows the current time zone and flashes. Press the Select Up/FF or Select Down/Rew Buttons to select the time zone. 3. Press the Time Zone Button again to (or if no key pressed for approx. 10 seconds) exit the setting mode. 4. If the time showing is not correct, please see Setting Time and Calendar to set the clock. Note: You can adjust the contrast of the display by pressing and holding the Time Zone Button until the zone display flashes, and then pressing the Preset 1 or Preset 2 button to achieve the preferred contrast. Setting Time and Calendar 1. Press and hold the Clock Adj Button located on the bottom of the unit for 2 seconds until display. Press the button again to accept the current setting or press the Select Up or Select Down Button until the current year is displayed. Press the Clock Adj Button to confirm year setting after adjustment. 2. The display will change to show the date flashing. the Clock Adj Button to accept the current setting or press the Select Up or Select Down Button until the current date is displayed. Holding the button will advance or reverse rapidly. Press the Clock Adj Button to confirm date setting after adjustment. 3. The time on the upper part of display the Select Up or Select Down Button until the current time is displayed. Holding the button for a few seconds rapidly. Remember to set the correct AM or PM. 4. Press the Clock Adj Button again to (or if no key pressed for approx. 10 seconds) exit the setting Charging your iPod Note: Please make sure you are using the correct insert for your iPod properly docked into the Failure to do so may damage 1. Press the Dock Open/Close to open the iPod 2. While your iPod (until 3. Press the Dock Open/again to close The iPod will whether 4. For iPod Shuffle, just plug connector will keep charging 13 Listening to Your iPod Note: iPod Shuffle operation differs from that of other iPods. (See the Shuffle section below for more on using your Shuffle). 1. Dock the already playing iPod. The iH36 will automatically turn on and you will hear the music playing from your iPod. Note: If the playing song/ music loudness on the iPod itself is too low, the iH36 may not detect that the iPod is in play mode. Press the iPod Play/Pause Button on the main unit (or Play/Pause Button on the remote control) twice to play it. 2. When the iPod is docked and in standby mode, press the iPod Play/Pause Button on the main unit (or Play/Pause Button on the remote control) to play it. The iPod Icon will appear on the display. 3. If the dock is closed and you are not using 3rd generation iPod or iPod shuffle, playing song info will show on the display. Note: When dock is closed, you can only play songs on current playlist. Note: When using a 5G iPod (iPod with video), make sure to exit video playback mode before closing the dock. Note: DO NOT close the dock while watching a video on the 5G iPod. 4. Press the iPod Play/Pause Button again to pause play; press again to resume it. 5. Press the Volume + and Volume – Button on the main unit or the remote control to adjust the system volume. Press the Mute Button to mute the output; press the button again to release it (restore volume). 6. Press Select Up/FF or Select Down/Rew Button on the main unit or the remote control to go to the previous or next track. Press and hold while track is playing for high speed forward or reverse music search of the current track. 7. To turn off the unit, press the Power On/Off Button on the main unit or the remote control. Your iPod will continue charging while in the dock. Note: Removing the iPod from the unit will not turn the iH36 off. Press the Power On/Off Button to turn off the iH36. Listening to iPod Shuffle Note: The iH36 will not control the iPod Shuffle. You must switch the iPod Shuffle on or off, and play or pause it manually. 1. Switch on your iPod Shuffle and play it. Then dock it into the 2. Press the iPod Play/Pause Button on the main unit (or the Play/Pause Button on the remote control) to play it. The iPod Icon will appear 3. Press the Volume + and Volume – Button on main unit or remote control to adjust the system volume. Mute Button to mute the output, press the button a...
Other models in this manual:Radios - iH36 (182.29 kb)