Votes - 0, Average rating: 0
(
)
)
|
manual abstract
If this occurs follow the instructions for emptying the container (19) and cleaning the filters. Emptying and cleaning the container -Pull upward the release handle (18) and take out the cyclone-tech unit. (Fig. 11) -Press the base flap release button (21) to open the base flap (20) and empty the contents into a dustbin. (Fig. 12) -The cyclone cone (24) should be cleaned after each use. To do this, turn the nozzle anti-clockwise in the direction of the arrow marked on it to remove it, knock out the dirt or rinse it when it’s very dirty. Turn it clockwise to fit it back. (Fig. 13) -The inside of the container can be wiped clean by using a damp cloth, and then left them completely dry before reusing. -Cover the base flap back up to close it again. Place the cyclone-tech unit back into its housing on the vacuum cleaner. -To ensure the best cleaning performance, be sure to press down the handle until it totally clicks into position. (Fig. 14) Cleaning the permanent HEPA filter The HEPA filter (22) should be cleaned regularly by knocking out the dirt and rinsing, and It is advisable to clean the HEPA filter at least six uses. -Pull upward the release handle and take the cyclone-tech unit out. -Remove the permanent HEPA filter (22) and sponge (23). (Fig. 15) -Tape it or wash them with water and mild detergent. Then leave them to completely dry. This vacuum cleaner has a missing filter detection system which prevents the cyclone-tech unit from being put back on the container when the HEPA filter is absent or not fitted correctly. (Fig. 16) Cleaning the air outlet filter -Release the two grill catches and remove the outlet filter grill (11). (Fig. 17) -Take the outlet filter (12) out and tap it or rinse it if very dirty. (Fig. 18) -Leave it to completely dry before fitting it back and reusing. Important: -Always switch off the vacuum cleaner and disconnect the power cord from the mains before cleaning the appliance. -The vacuum cleaner must never be switched on unless these filters are fitted correctly. -Do not use a scourer, glass-cleaning agent or multipurpose cleaning product. -Never immerse the whole vacuum cleaner in water. -To guarantee trouble-free operation only use original Ufesa filters. -Ufesa recommends that the HEPA filter and the air outlet filters be replaced yearly (depending on use). You can find these replacements at your local shopping center. BRUSH FOR WOODEN FLOOR (16) This brush has been specially designed to clean wooden floor surfaces. The soft hair bristles brush over the surface picking up the dust but without damaging the floor. BEATER BRUSH FOR RUGS & CARPETS (17) (Only for AC6220) This brush is specially designed for cleaning rugs and carpets. The rotating brush beats gently against the carpet fibers for deeper cleaning. ACCESSORY Upholstery nozzle (13) This accessory has been designed to clean all types of upholstery. Furniture nozzle (14) This accessory is ideal for vacuum cleaning furniture and other delicate surface, prev...
Other models in this manual:Vacuum Cleaners - AC6220/01 (1.64 mb)
Vacuum Cleaners - AC6230/01 (1.64 mb)