Votes - 1, Average rating: 5
(
)
)
|
manual abstract
Indicator will show a green window next to TOOL (D) when handle is in the upright position for tool use on stairs upholstery etc. Deep cleaner automatically divert suction from FLOOR toTOOL when handle is raised from the operating to the upright position. To transport • q To move your deep cleaner from room to room put handle in upright and locked position tilt deep cleaner back on wheels and push forward. • q The deep cleaner may also be lifted by placing a hand under the upper clean solution tank handle as shown. El El When the recovery tank (lower tank) is full the automatic shutoff mechanism will shut off the deep cleaner suction (suction will be noticeably reduced). At that time the red float disk will rise to the top of the recovery tank lid (E). The deep cleaner will no longer pick up dirty solution and the motor sound will become noticeably higher in pitch. When this happens turn deep cleaner off and empty recovery tank before continuing use. Check clean solution tank also; it may need to be refilled. Agitator Speed selector • q Your ‘SteamVac’ deep cleaner has three agitator brush settings. HI - for normal cleaning of carpet and bare floors LO - for gentle cleaning of carpets and bare floors OFF -for cleaning carpets and bare floors when brushing is not desired. (Such as when picking up liquid spills. See page 10.) Slide selector button to the desired setting before cleaning. Brush indicator The brush indicator will spin (F) a when the deep cleaner is turned ON and the brushes are rotating. If the indicator does not spin and the pattern is visible (G) when the deep cleaner is turned ON, the brushes are not rotating. There are three reasons why the brushes may not be rotating: 1. Brush speed selector set on OFF (see previous section). 2. Handle in upright position (see “Cleaning mode indicator,” p. 6). 3. Brush indicator screen dirty. • q To clean screen (H), turn deep cleaner off and disconnect from electrical outlet. Remove clear cover and wipe off screen with a damp cloth. Snap cover back into position. The tanks Clean solution tank (upper tank) The clean solution tank holds the cleaning solution that is to be dispersed onto the surface to be cleaned. How to fill Disconnect deep cleaner from electrical outlet. • q : Place deep cleaner handle in the upright, locked position. To remove tank, press down on handle and pull forward. Carry tank to a sink. Continued + Using cap, measure detergent following the chart below. For carpet, carpeted stairs and upholstery: Fill cap to fill line (5 ounces) with HOOVER CarpetiUpholstery Detergent For bare floors: Fill cap to fill line (5 ounces) with HOOVER Bare Floor Cleaner Do not use Bare Floor Cleaner on carpet or upholstery. Do not use any type of wax with your ‘SteamVac’ deep cleaner. •• .q Rotate tank cap counterclockwise Turn cap (A) upside down to serve NOTE: Use only HOOVER detergents. and lift up to remove cap. as a measuring cup. They are specially formulated for use with your ‘SteamVac’ deep cleaner. For heavy traffic areas: Pre-treat with HOOVER PreCleaner Spray. If you do not have access to the PreCleaner Spray, double the amount of HOOVER Detergent (use 2 capfuls or 10 ounces per 1 gallon tank). CAUTION: Detergents contain Anionic and Nonionic Surfactants. Avoid contact with eyes and skin. In case of contact with eyes, flush with cold water for 15 minutes. In case of contact with skin, wash with water. If Irritation persists, call a physician. For Medical Information (U.S.) call l-800-752-7889. • q Pour detergent into tank. Fill tank If rubber ring (C) on cap has to fill line (B) (1 gallon) with hot become dislodged, reposition it tap water. with uneven side against ledge (D) as To assure proper performance, use only shown. HOOVER cleaning detergent. Recovery tank(lower tank) The recovery tank holds the dirty solution that is picked up from the carpet. When the recovery tank is full, the automatic shut-off will engage (see page 7) and the tank must be emptied. How to empty Turn deep cleaner off and disconnect from electrical outlet. To prevent possible leaking, remove clean solution tank (Fig.28) by pressing wise until it locks In place. Cap qand press on tank handle to snap • q Replace cap. Rotate cap clock-, Position bottom of tank into unit down on tank handle and pulling for- ward; set tank aside (do not set tank must be locked In place for proper tank into place. on furniture). performance and to prevent leaking. Step on handle release pedal (Fig. 20) and lower handle until it rests on the floor. • q Raise handle to carrying position (straight up) to unlock tank from base of deep cleaner. Lift tank from deep cleaner and carry it to a sink or drain. • q , To remove tank lid, lower handle completely toward back of tank and lift off lid. Empty the tank and reposition the lid. For full suction, it is important that the recovery tank lid is properly secured before cleaning. Raise tank handle to carrying position to place it into base of cleaner. ...
Other models in this manual:Vacuum Cleaners - Ultra Plus (1.54 mb)