Votes - 0, Average rating: 0
(
)
)
|
manual abstract
. Fully extend the power cord when using the vacuum cleaner continuously for several hours. . When disconnecting the appliance from the mains, pull the plug, not the power cord. . Do not pull the power cord around sharp corners or allow it to become trapped. . Unplug the power cord from the mains before carrying out any work on the vacuum cleaner or its accessories. . Do not use the vacuum cleaner if it is damaged. Unplug the power cord from the mains if a fault is detected. . Only authorised after-sales service personnel are permitted to carry out repairs and fit replacement parts. en . The vacuum cleaner protected from the weather, moisture and sources of heat. . Switch off the vacuum cleaner when is not in use. . At the end of its life, the vacuum cleaner should be rendered unusable and disposed of in an appropriate manner. . For safety, the vacuum cleaner is fitted with a temperature safety switch, which automatically switches the vacuum cleaner off if it is blocked and overheating. Unplug the power cord from the mains and make sure that the nozzle, tube and hose are not blocked. Also check whether the filter needs changing. Having cleared the blockage, leave the vacuum cleaner to cool down for at least an hour. It can then be switched back on again. Disposal information . Packaging The packaging is designed the vacuum cleaner against during transportation. It is made of environment-friendly materials and can be recycled. Dispose of unneeded packaging at the appropriate "Gruner Punkt" collection point. Used vacuum cleaners Old appliances still contain many recyclable materials. Please take your old cleaner your retailer or recycling centre so that it can be recycled. For current disposal methods, please enquire at your appliance dealership or local council. ! ! Please note Only connect the appliance to a socket that is protected by at least a 16 Amp fuse. If a fuse should blow when you switch on the vacuum cleaner, this may be because other electrical appliances which have a high current draw are connected to the same power circuit. To prevent the fuse from tripping, select the lowest power setting before switching the vacuum cleaner on, and increase the power only once it is running. en en Setting up Figure 1 a) Push the hose connector into the opening on the vacuum cleaner until it engages. b) To remove the hose, press the lug and pull out the hose. Figure 2 a) Connect the handle and the suction hose together. b) Connect the hand grip and telescopic tube together. Figure 3 Connect the floor tool and suction pipe/telescopic tube together. Figure 4 a) Connect the suction hoses together. b) Disconnect the telescopic tube and adjust its length by moving the adjusting button/sliding sleeve in the direction of the arrow. Figure Holding the power cord by the plug, pull out the required length and plug it into the mains socket. 5 Figure Press the on/off button to switch your vacuum cleaner on/off. 6 Figure Adjust the vacuum power by turning the power control. 7 Vacuuming Figure Figure Vacuuming with accessories (attach to hand grip or suction hose as required). Adjusting the floor tool: rugs and carpets => hard floors => 9 8 a) Crevice nozzle For cleaning crevices and corners. b) Upholstery nozzle For cleaning upholstered furniture, curtains, etc. c) Hard-floor brush For cl...
Other models in this manual:Vacuum Cleaners - BBS6004/08 (2.12 mb)
Vacuum Cleaners - BBS6002/08 (2.12 mb)